.
I assume you mean relative humidity of saturated solutions of those salts?
For KOH the data and temperature dependence is in the Greenspan paper:
http://nvlpubs.nist.gov/nistpubs/jres/81A/jresv81An1p89_A1b.pdf
For copper sulfate I have a table here that gives 95% at 30°C and 98°C at 20°C, but no parameters for the temperature dependence.
regards,
Pieter
For potassium hydroxide the data are reported at:
http://www.engineeringtoolbox.com/salt-humidity-d_1887.html
Dear Peter
thank you so much for your answer.
kindest regards
Dear Dr.Bernardo
thank you so much for attached paper.
Aida
I wanna know the proper temperature, humidity and duration of soil sterilization, and also possible chemicals applicable for soil sterilization. looking forward to hear from you colleagues.
11 December 2017 5,735 4 View
in fact, I have used formalin & KMnO4 for disinfecting a tissue culture lab & growth room, but the smell have not removed after 4 days, how can I get ride of it? any practical method to...
11 December 2017 842 10 View
I wanna know if foliar application of amino acid solutions is an appropriate method? if not, what is the best method to apply amino acids on plants?
09 October 2017 7,012 5 View
08 September 2017 219 4 View
31 December 2016 5,619 9 View
11 December 2016 9,720 1 View
09 October 2016 5,754 9 View
06 July 2016 6,355 8 View
06 July 2016 4,336 0 View
Excessive rotation of nodes in node set ErrNodeExcessRotation-Step1
17 August 2021 0 0 View
How to calculate the RMSD values for a MD simulation using MOE?
07 August 2021 0 0 View
20 June 2021 0 0 View
When I tried to energy minimization my system, I got fatal error as below. Fatal error: Atomtype opls_116 not found Although I've already added this line: ; include water #include "oplsaa.ff/spc.itp" to [molecultype] directive in my topology.
16 June 2021 0 0 View
What this unit identifies for the ion exchange capacity ca. 0.92 meq. g-1. I am a newcomer in the membrane area. I just started. I highly appreciate your help
08 May 2021 0 0 View