How to extract the charge density in the semiconductor channel (σMOS) from Silvaco TCAD?

01 January 1970 0 1K Report

Now I'm working on MOSFET fabrication using Silvaco TCAD, i want to extract the charge density in the semiconductor channel (σMOS).

Badges
Science topic

More Ahmed Musa Dinar's questions See All

How to calculate pH response i mean pH sensitivity value (mV/pH) for ISFET device already fabricated using TCAD?

01 January 1970 8,510 1 View

How to calculate pH response i mean pH sensitivity value (mV/pH) for ISFET device already fabricated using TCAD?

pH sensitivity

01 January 1970 8,494 0 View

¿Are oxygen vacancies in semiconductors capable to change the band gap?

Dear all! Oxygen vacancies do raise negatively the Fermi level by increasing the negative charge in the semiconductor crystal structure. In the case of n-type semiconductors, I wonder if this...

30 July 2024 8,339 2 View

How to build my own lab made four point probe set up?

Hello, I'm trying to measure the conductivity of semiconductor films but since I don't have a commercial four point probe set up I would like to build one on my own in my lab. I have generators,...

30 July 2024 906 2 View

How can I calculate AlGaN/GaN HEMT Breakdown Voltage on Silvaco TCAD?

Hello, I'm newbie to TCAD. I wanna calculate Breakdown Voltage of AlGaN/GaN HEMT. But, my code shows just saturation. Could you please help me how to simulate Breakdown Voltage of my code? And...

25 July 2024 3,738 1 View

How can i solve the code problem in Sentaurus TCAD?

Currently, I have created a gate-all-around process using sentaurus tcad and I am trying to measure the noise using the cmos noise code. However, an error occurred during the simulation. The error...

24 July 2024 6,352 0 View

How do you decide an optimal AC amplitude for non-faradaic electrochemical impedance spectroscopy?

I work with planar interdigitated electrodes (IDEs). The finger width and the spacing between the fingers are 5 micron. The surface of the IDEs is coated by a non-conductive polymer layer...

16 July 2024 5,031 1 View

What is the difference between alluvial and fluvial?

I have made an unpleasant discovery that I seemed to use these terms incorrectly. 'Alluvial' seems to mean "out of the river channel", flood-plain' etc. While all these cross-bedded...

15 July 2024 2,073 3 View

How to add channel doping variation in sentaurus tcad to see its effect on transfer characteristics of mosfet?

I am getting trouble in studying the effect of channel doping variation in forksheet structure for p and nmos.

08 July 2024 2,074 0 View

What is the best software for simulation of mode locked diode laser?

Hi Dear All I would like to simulate a mode locked semiconductor laser. Does anyone know what is the best software to do it?

06 July 2024 1,648 4 View

TCAD how should i define this Doping Dependece?

The material is SiGe

03 July 2024 1,374 0 View

Taking a cut line through deck build in silvaco?

Hi everyone hope your all doing good. I’ve been looping my scripts and am trying to take a cut line of the conduction band energy with respect to y for each loop. Basically, I want to take a...

03 July 2024 9,134 1 View