Hello everyone, I am learning how to drawing geometry earth dam on flac 3d. I have a problem with bad blocks. I cant make zone because notification says "bad blocks". I started draw 2d geometry dam on extrusion pane then i use autozone tool and blocking tool. And then i extrude the geometry. I do the same thing when i draw geometry canyon. After dam and canyon have extruded, i go to building blocks and combine the dam and canyon so there are intersection between dam and canyon blocks.
Have I done the right steps? could anyone tell me the right step for drawing 3d geometry dam and canyon? Thank you
Hi Haidar Hosamo thank you for comment.
i have pass step 4 and 5, when i want to validate, there is notification "there are 60 non-valid blocks in current set "model". what i have to do next?, i want to do seepage analysis, stability check up/down stream etc.
In flace 3D, you are able to write the code for defining line, angel and etc.
You can draw the model geometry in Auto CAD and enter as a input in FLAC 3D.
- Badges
- Science topic
- Similar topics
- Correction