What are different ways to check for calibration and laser problem in DLS-zeta machine?

while measuring the zeta potential of sample, results are not consistent showing a high standard deviation for each measurement. For HPLC water it is showing a negative value of 2 mV with standard...

08 September 2019 2,170 3 View

What is the difference between Montmorillonite and Montmorillonite K10 ? which is to be used in evaluating oil recovery ?

i want to know the difference between them ? and which is to be used in evaluating the oil recovery ? whether both can be used or not ?

02 March 2019 4,596 2 View

Can Interfacial rheology between crude oil and brine be measured with cup and bob type rheometer?

i am looking to measure the elastic modulus and viscous modulus of oil and brine interface.

04 May 2018 9,597 2 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

In an eye with Tyndall, does each dot correspond to an individual cell?

When you observe the presence of Tyndall in an inflamed eye: Does each of the small floating dots correspond to an individual cell or to an aggregate of cells? Does a conventional slit lamp have...

27 February 2021 6,326 2 View

How to calculate the crystallinity of cellulose film?

27 February 2021 2,753 4 View

What could be the reason for not having further low chi square value (better agreement) in my refinement result?

I have tried every combination of parameter changes and after that i have a poor chi square value. I can't get it lower any further. I know there have been a lot of discussion about Rietveld...

26 February 2021 8,480 3 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

I have need of XRD graph analysis software for phase identification. Can you please provide links for software tools which can be downloaded?

i am trying to download x'pert high score software, but can't download it. please do suggest software for phase analysis

24 February 2021 5,687 4 View

Why the CHi^2 is close to zero with a bad fitting but the Rp and Rwp are still high?

I am refining my XRD data using in FullProf program. The intensity of the modulated X-ray peaks is almost flat. I tried to adjust the peak intensities but unsuccessful. What is the reason? I guess...

23 February 2021 2,304 4 View