What is the drug induced splenomegaly?

Greetings everyone. Please I am running a research on splenomegaly and I have a problem of the drug that can be used to induce splenomegaly. I have seen Chemotherapeutic drugs but wasn't giving...

09 September 2020 4,102 3 View

What could happen if I stop a PCR reaction to add a component I missed out during the mastermix prep?

Let's say I forgot to add the polymerase enzyme and I only realize this after the run has gone half way, could I stop the reaction to include the pol...would I get amplification if I reprogram...

13 September 2019 3,211 3 View

Can heparin tubes be used to collect blood samples for Plasmodium falciparum microscopy?

I need to collect blood samples for microscopy of P. falciparum. Which tube is best for this? Heparin or plain vacutainer tubes? Will RBC lysis affect detection of the parasite? Thank you.

23 April 2019 8,803 4 View

How do I preserve stool samples until the required sample size needed for further analysis is obtained?

I'm currently collecting stool samples for Rotavirus ELISA assay. Please how do I preserve the stool samples until number of samples needed are complete and how long can I preserve these samples...

17 April 2019 2,270 4 View

Could anyone please help me with step-by-step guide on how to run my meta-analysis on STATA 14.2?

I want to do a meta-analysis of previous prevalence studies for 2 subspecies of an organism in a particular location and I need to calculate/derive these: 1. Confidence Interval for individual...

19 June 2018 4,721 2 View

What's the best protocol for isolating plasma circulating host DNA to HTLV?

How do I isolate plasma circulating DNA of host to HTLV?

24 September 2017 1,928 2 View

Can someone suggest to me a journal in finance and banking or the general area of management that does not charge APC

I need a place to send the product of this project for publication.

20 May 2017 7,925 2 View

What is the effect of non-vacuum plain tube on blood serum as compared to vacutainer plain tubes?

Some hospitals, due to cost, (especially in the under-developed and developing countries) use non-vacuum plain tubes for serum where methodology stipulates the use of vacutainer plain tubes. Can I...

24 July 2016 507 5 View

Why is the concentration of ammonia in my reactor is decreasing while nitrite is increasing?

I am trying to establish anammox bacteria to coexist with ammonia oxidizers. Can someone explain to me why the concentration of ammonia in my reactor is decreasing while nitrite is increasing...

19 January 2015 9,816 7 View

Can anyone direct me to a good DEA software or add-in?

06 October 2014 4,157 31 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

Energy minimization in LAMMPS using NVT ?

How do I do energy minimization in lammps with NVT ensemble ? I am using the following command and it does not seem to work. It stops at extremely high energy and gives me the error zero search...

01 March 2021 2,294 3 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

How can I edit suggested publications?

Hi there! I regularly receive suggestion about papers and authors that are totally out of my area. Does anybody know how I can fix this? Thank you!

01 March 2021 9,574 4 View

How to show arrows over the streamlines in CFD-post?

I follow this to make streamlines like the photos attached below: (software- CFD post-processing) First I plot the 2D streamline over a surface "streamline 1". them I plot a vector by the...

01 March 2021 8,668 3 View

How to increase mesh quality of a cfd model in ansys fluent?

How can one improve mesh skewness, orthogonality, aspect ratio?

28 February 2021 7,730 3 View

Is anyone familiar with the cyclic compressive fatigue testing (BS EN 12697 - 25) ?

I would like to get more information on the cyclic compressive fatigue testing (BS EN 12697 - 25) which is typically done for bituminous material in pavement design. Any one can advise on the...

28 February 2021 2,004 3 View

No title

I am trying to find how to know the density needed for a pva electrospinning in a 0.6mm neddle, the electrospinning will be from top to bottom and the problem I really have is the solution because...

25 February 2021 2,615 3 View