How to convert rmsd graph containing frames on x axis into time in ns?

01 January 1970 0 3K Report

I have obtained graph containing 5000 frames on x axis I want to convert it into time i.e.100 ns. I am using amber 20 which is GPU based.

Badges
Science topic

Similar topics
Filing

More Amanpreet Kaur's questions See All

How to draw a graphs of bioconcentration of pesticide and its relationship with log Kow, log Sw and molecular weight?

Help me to draw graph of Bioconcentration

10 June 2024 4,941 2 View

How to estimate total sugars using lane and eynon method?

I want to estimate total sugars in carrot and products developed from it. I have been using lane and eynon method. I could get the values for reducing sugars but not for total sugars. What is the...

28 May 2024 9,382 4 View

Dissertation topic for MSC Computer Engineering Students?

My name is kiranbir kaur and m student of MSC Computer Engineering in Solent University Southhampton (United Kingdom).Please suggest me the topic for dissertation.Include the Problem and Solution.

24 May 2024 4,355 2 View

Dissertation Topic for MSC computer Engineering?

Hi, My name is kiranbir kaur and m student of MSC Computer Engineering in Solent University Southhampton (United Kingdom).Please suggest me the topic for dissertation.Include the Problem and Solution.

24 May 2024 1,180 3 View

Why total dissolved solids (TDS) are not reduced after treating waste water by vermifiltration process?

Dear researchers, I am treating the waste water by vermifiltration process using different filter bed media. After the treatment, BOD, COD, TSS were found to be reduced but reduction in total...

18 May 2024 1,897 3 View

What formula we use for calculation of anthocyanin from optical density values?

Using 10 ml of 1% methanolic hcl, 1 g fresh sample and OD at 530 and 657nm

07 May 2024 4,440 1 View

Could you help related to the following Optimization issue in DesignBuilder?

I made a DesignBuilder model that includes PV solar collectors using two electric load centers. After simulation, the annual PV generation was about + 3700 KWh. Then, I identified an...

24 April 2024 4,733 4 View

Can i use ASTAM D 1002 for lap shear strength of wood substrate ?

which ASTM D USE for lap shear strength in UTM of wood substrate

04 April 2024 4,791 0 View

Hello everyone i have some problem when i am installing cooja 3.0 in ubuntu 18.04? give me some solution?

when i am installing cooja 3.0 in ubuntu 18.04 i am facing some problem give me some solution

01 April 2024 4,305 0 View

In the synthesis of nanocomposite material, if amount of components doubles, should the reaction time (blending time) also be increased?

While synthesising nanocomposite material by blending one component over another, it was observed that if amount of components is doubled/increased without increasing blending time (i.e., kept...

19 March 2024 2,781 2 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

How to know the b axis of a single crystal?

How to apply magnetic field parallel to b axis of any crystal

29 July 2024 4,083 2 View

MAGeCK Plotting Error: Logarithmic Axis Must Have Positive Limits?

I have been running a MAGeCK test command on the terminal for a CRISPR screen to rank sgRNAs and genes based on the read count tables. However, I get only the plot of the top-ranked genes...

28 July 2024 9,811 1 View

I did hirshfeld surface analysis for molecule but did not find red spot and interaction surface in energy frame work, is it ok for research article ?

In hirshfeld surface calculation i did not find any red spot in hirshfeld surface, is it ok for research article to write?

28 July 2024 2,988 0 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Using a large amount of data, such as 30 years of daily data, in a machine learning model like LSTM can reduce the model predictivity?

I have used 30 years of daily data, but the model is not able to optimize, getting just 0.57 in NSE and R2. when I reduced the data to 20 years in daily time frame I got 0.73 in NSE, R2 for both...

22 July 2024 669 0 View