You have all most all the basic logs to deine your HC type and thus the contacts. YOu can display your logs on triplecombo template. Can read about triple combo over here.

https://agilescientific.com/blog/2013/1/15/rocks-pores-and-fluids.html

You can read this blog on how to read logs to identify fluids and their contacts.

https://www.linkedin.com/pulse/six-ko-rules-easily-detect-oil-gas-water-from-well-log-dosh-nazlan

Here you can have petrophysical parameters: NtG, Porosity and water saturation.

Prepare a map for your reservoir.

Go to map based volume calculation module.

Insert all the PP parameters, Map and Contact and press RUN

you will get the results in an output sheet.

Enjoy.

Permeability and oil-water contact depth are input to Petrel, not output. You have to obtain permeability and depth of oil-water contact outside Petrel, and then you can input them in Petrel.

Hydrocarbon saturation can be obtained either externally (by using a petrophysical analysis software to analize the available logs) or internally in Petrel, by using special Petrophysical Module(s).

you just need the required license as Techlog !

for permeability you need a vertical and horizontal core permeability than you do a correlation between well logs and the core permeability finally you can use the correlation to fine permeability log (continuous reading)

For you to estimate hydrocarbon saturation, first you need to have formation water resistivity Rw. If this is not provided then you need a deep resistivity-porosity crossplot (Pickett plot) to determine Rw, Techlog can help you do that. You can then apply any of the saturation models, i.e., Archie's empirical model to determine water saturation.

Note that Sw + Sh =1

where Sw - water saturation

Sh - hydrocarbon saturation

I hope this will help you. Goodluck