We have ran some Coronavirus samples on MinION using MinKnow with the Guppy basecaller on. Unfortunately, we had to re-run later to get enough reads, however, on this second time we left the Guppy off ! All these using windows 10.
How do I run this last data on Guppy separately, using windows instead of command line? I would appreciate your comments.
Thank you for the help
Regards
Flavio
Luis A. Tataje-Lavanda
I have only found how to run guppy on windows with commands.
https://community.nanoporetech.com/protocols/Guppy-protocol/v/gpb_2003_v1_revac_14dec2018
(You must enter the link with your nanopore account)
0 votes
0 thanks
More Flavio F Alcantara's questions See All
Similar questions and discussions