I need some help with VISSIM. I have modeled an intersection where I would like to use no-changing lane rules near 100 ft of the traffic signal. Picture 1 shows intersection without applying lane change restriction, where vehicle 1 and vehicle 2 are changing lane near the traffic signal.
However, after applying no-lane change near the traffic signal, I found the picture 2 for EB direction. Actually, those two vehicles from picture 2 would like to turn left, but they are in no turning section. Therefore, they are not moving.
How may I apply no-lane changing near an intersection?
It is more important to attend to the lane change and emergency stop distances on the connector. Focus on these values before attending to the parameters on the link.
Hi
you may use pavement marking to apply no lane change near an intersection in VISSIM..
good luck
Hi,
You shall make the connector sufficienctly long (say 100ft as per your requirement), and enable the NoLnChRAllVehTypes and NoLnChLAllVehTypes parameters in the link properties for the connector. Also, to prevent vehicles from having to make last minute decisions on changing the lane to follow a desired route, introduce the vehicle route decision point well upstream of the connector.
Hope this helps.
Best wishes,
Abdhul
- Badges
- Science topic
- Similar topics
- Phytochemistry
- Extracts