How to analyse the SADP pattern in TEM ?

05 May 2013 1 5K Report

I am getting a pattern (SADP) which is different from the XRD pattern. How can we determine different things from this pattern?

Also what are the things that we can extract from this pattern ?

Arun Karthick

if its same material for both XRD and TEM u have to get same patter. for the peaks obtained in XRD u can find tha corresponding (h,k,l) value which is used to get your crystal structure. same for SADP pattern from TEM

Badges
Science method

More Prakash Mahakul's questions See All

Dear All, Can anyone please tell my the possible reasons for not getting diode characteristics of solar cell ?

My device structure is ITO/PEDOT:PSS/Active layer/Al. Here i am using p3ht-cnt composite as the active layer. During dark i-v measuring i am not getting the usual diode characteristics for the...

31 December 2015 6,477 6 View

How can I take the c-v characteristics of P3HT film deposited over glass substrate ?

I am interested for capacitance voltage measurement of p3ht film. I am depositing aluminium dots above the p3ht film. But when i am measuring the c-v characteristics, am not getting the data as...

04 May 2015 1,951 9 View

Which is the best solvent for dispersing RGO without functionalizing it?

There are lots of articles that describe the dispersion of RGO. But most of them are by covalent functionalization. Though it enhances dispersion but degrades the properties of the material. Hence...

06 July 2014 522 11 View

Can someone help me calculate the electron and hole mobility from R-T measurement?

I have prepared a polymer composite film. I want to compare the charge mobility. Could somebody please help me with some references?

04 May 2014 8,144 3 View

How can I coat a thin layer of PEDOT:PSS over SiO2 so that I can characterize its film thickness?

I have prepared a thin film of PEDOT:PSS over SiO2 substrate. I tried masking the substrate with teflon tape but the solution get stuck near the teflon tape and the thickness there is greater...

04 May 2014 7,826 5 View

I have prepared reduced graphene oxide using solution method. Can someone explain to me how to filter to get the required material?

Here I am using PTFE filter paper, but it is very much brittle. It can not be bent or folded. So it is being very difficult to filter. Please explain

03 April 2014 1,902 3 View

How can we measure the smoothness of thin film?

Sometimes relation between different layers (thin films) of device play an important role in device performance. So it needs to be optimized.

02 March 2014 351 7 View

Can someone please explain the meaning of 2.5 wt% dispersion in H2O?

I am interested in preparing a composite with PEDOT:PSS. But I don't understand how to maintain the ratio as I don't understand what 1.3 wt% dispersion in H2O means.

01 February 2014 2,543 3 View

How can we allign carbon nanotubes in a polymer matrix?

Polymers with CNT filler have proved themselves as important candidates in the category of polymer composites due to their good physical properties. Hence can we in some way align them in an easy...

01 February 2014 9,405 17 View

How can I prepare Graphene using the electrolysis method?

Graphene has been a material of interest since its discovery in 2004 on account of its excellent physical properties. Can someone please explain the synthesis of Graphene by electrolysis?

31 December 2013 3,828 3 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

Guidelines for survey (question type) analysis?

Hi. Please tell me what guidelines should i need to follow for questionaries' type research work in India. It is not hospital based work, we are conduction basic institutional based qualitative...

03 March 2021 2,037 3 View

Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence?

I am on the lookout for the Enhanced Yellow Fluorescent Protein (Aequorea victoria) DNA sequence. Does anyone know where I can find it? Thank you in advance

03 March 2021 3,568 1 View

What kind of fluid could I use for a pitfall trap that also does not invalidate molecular testing?

Hi, I want to start testing pitfall trap to obtain ants samples, but I need to conduct molecular analysis on those insects. So, what kind of fluid can I use? Ethanol expires too early and I need...

03 March 2021 5,978 5 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

Do we need to write protocol for a second study of a systematic review that has been registered and published?

I have conducted and published a systematic review and meta-analysis research with the topic related to public health and health pomotion (protocol was registed in PROSPERO). Now we want to...

03 March 2021 8,920 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

I need to image mesoporous silica nanoparticles that are in ~100 nm size and do high resolution TEM to look at mesopores. what grids should I use?

Need to image mesoporous silica nanoparticles using the TEM. Also, need high resolution TEM images to see the mesoporous structure. Kindly suggest what kind of grids to use. Thanks, Shatadru

02 March 2021 1,787 2 View

How to access MSCI KLD Stats and Sustainalytics?

Hello all, I'm currently working on my undergraduate thesis and I'm having difficulties trying to access KLD Stats and Sustainalytics because my campus Airlangga University and apparently other...

02 March 2021 8,525 1 View

Do I need to do linear regression before running mediation analysis using PROCESS MACRO by Hayes ?

I just wanted to check if I need to run a linear regression separately if I am using PROCESS MACRO to run mediation analysis. Thank you.

02 March 2021 4,359 3 View