How TGA curve behaves on CNT-CNT interaction at high weight percent in polymer matrix ?
It's highly dependent on what polymer you're using. In most of the cases three staged degradation will be observed.
It is not a pertinent technique to study CNT-CNT interaction. However, to a low % system, higher % system shows marginal improvement in IDT.
The formation of chloride ion (as HCl used as dopant) in the polymeric chains (polyaniline) stabilize it or destabilize? Please open the discussion
04 May 2017 1,592 9 View
Can we use the word hybrid to designate polymer-CNT nanocomposites i.e., hybrid polymer-CNT nanocomposites? Here I attached some literature where people frequently used it and published paper in...
01 February 2017 4,256 4 View
How hydrochloric acid as a dopant in polymeric chains of polyaniline enhance the thermal stability ?
01 February 2017 9,337 4 View
Is DMSO has doping effect on the polyaniline? If we prepare the PANI-CNT nanocomposites (DMSO as a common solvent for both )?
01 February 2017 7,018 4 View
What kind of morphology can be observed in self- standing film of polyaniline ? Please open the discussion.
31 December 2016 2,331 0 View
Sometimes PANI shows a single halo and sometimes it shows 3-4 sharp peaks. When and why these conditions occur in different cases. please elaborate the discussion about it.
11 December 2016 7,245 5 View
How the rate of chemical reaction affects the crystallinity of polyaniline nanocomposites
10 November 2016 2,375 3 View
How concentrated HCl affect the branching of polyaniline membrane
10 November 2016 3,798 3 View
Can we measure the Stress Strain curve of nonuniform polymeric membrane ?
06 July 2016 5,274 1 View
How CNT-CNT interactions at higher concentration in polymer matrix affects the intensity in FTIR ?
06 July 2016 8,638 5 View
I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...
10 August 2024 3,629 1 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
How do interactions between the biosphere, the carbon cycle, and the water cycle impact global warming and interaction between the atmosphere and the hydrosphere?
09 August 2024 3,291 2 View
Global ‘Weather’ has stopped, as ‘aqua thermionic instituted by the ‘Global thermo atmospherics has instituted global thermodynamics of 120º C + and thus all waters are, or have boiled into a...
06 August 2024 8,716 0 View
What is the method for analytically calculating the wear and service life of polymer-polymer sliding pairs?
04 August 2024 1,078 1 View
The starting material is a finely ground powder. Some particles contain more graphene than others.
30 July 2024 3,978 2 View
I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...
30 July 2024 6,137 0 View
Hello everyone, I am try to understand the differences interaction between insoluble and soluble polymers in water with metal ions and how theit charge density (of metal ions) affect the interaction.
29 July 2024 6,350 3 View
A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids
28 July 2024 4,985 1 View
I have different polymer solutions and I hypothesize that water molecules are retained based on the water-polymer interactions, so the amount of free water is less to intercat with drug tablet....
28 July 2024 9,545 6 View