How do I use voice recognition to a motor with 220 volt? Programmed with 12 volt controller?

More Sara Elhawary's questions See All

Do I need to strip the PVDF membrane before staining it with colloidal gold?

Dear Colleagues, After running Western blot on PVDF membrane and detection using ECL, I would like to stain my PVDF with colloidal gold to be able to allign the ECL image with total proteins on...

02 March 2021 7,829 3 View

Shall I skip the measurement model in SmartPLS?

Hello everyone, I had run a mediation model in SmartPLS using questionnaires that were already validated among my statistical population. A professor who edited my paper -though she is not...

01 March 2021 3,052 3 View

Have anyone checked before Cyclic voltammograms of intial ITO substrate and E-teck?

As a beginner in electrochemistry, I tried to obtain cyclic voltamograms of commercial anatase powder deposited on an ITO substrate or on Eteck. After several attempts, I noticed that my cyclic...

23 February 2021 3,175 3 View

Is it okay to mention you distributed your qualitrics study link through social media sites?

Just want to be clear and know it is okay to say I have distributed the qualitrics link through social media such as Facebook, Instagram and Twitter to ensure my target audience is reached in my...

21 February 2021 5,143 2 View

Why samples do not run in resolving gel?

Hello everybody, I have a problem with SDS-PAGE and I do not know why my samples stop at the top of the resolving gel and they do not run through it. The percentage of gel is 15% and the size of...

14 February 2021 9,116 6 View

Do you know of an informal caregiver of a person who has recently received a bone marrow transplant?

We are conducting a pilot study of an intervention for informal caregivers of persons who have recently received a bone marrow transplant in the US. If you know of anyone who might be interested,...

13 February 2021 9,174 1 View

Is it possible that the single-pass absorption exceeds 50%?

Dear researchers It's well-known that the maximum light absorption of any structure can not be greater than 50%. Is it possible that the single-pass absorption exceeds 50%? How?

17 January 2021 2,335 7 View

Most appropriate fit of a standard curve in an enzym-linked lectin assay?

Dear all, I have a question regarding the most appropriate fit of a standard curve in an enzyme-linked lectin assay set-up to quantify the amount of mucin secretion in conjunctival explant...

03 January 2021 1,010 6 View

How do I access Domestic Violence Attitude Scales or find them for free?

Hi, I'm a postgraduate student currently starting up a research project on attitudes towards domestic violence (DV). The study will aim to compare cultural differences between attitudes and...

31 December 2020 781 3 View

A good protocol for protein purification by AKTA?

Hi everybody, Does anyone have a good protocol for protein purification using AKTA? I have tried to purify two proteins but after several attempts it was not successful. So, I really appreciate...

28 December 2020 5,220 15 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

Open Source IoT Simulators supported by Machine Learning?

Dear Research Gaters, Let me first add context to the question. I am looking to simulate the waste management system and resources of a city. The hardware devices I need to simulate include,...

21 February 2021 2,333 4 View

What type of pressure sensor are usually used in microfluidics?

My team is designing a dual channel microfluidic chip that runs air and water. I think we've decided on the NE1000 syringe pump for it's versatility and feedback control. We will be ordering the...

18 February 2021 9,928 2 View

How to realize refractive index values of 1 to 1.1?

Hello researchers! While studying the literature on refractive index sensors, most of the articles simulate their devices with a refractive index ranging from 1 to 1.1, with small steps in...

17 February 2021 1,578 4 View

What should a smart water system look like?

Our team is designing a smart water C&C dashboard for a smart city initiative. As we look into the current smart water system landscape, we couldn't reconcile to a definitive solution that...

16 February 2021 1,094 3 View

Which DL architecture is better to work on handwritten data?

I am working in the area of Handwriting recognition for Bangla. As there are many DL architecture, I am confused which one to select.

15 February 2021 4,996 1 View

Receiving very less number of hits and events in acoustic emission tests?

I am doing a three point bend test with concrete specimen of dimension 280mm*90mm*90mm. I am putting 2 sensors near the notch with 3cms away from both the sides. the experiment ran for 20 mins but...

13 February 2021 2,990 1 View

How to obtain regions around the person bounding boxes(excluded the detected people in scene)?

Hi all. I have a set of coordinates of bounding boxes for AVA Dataset. This dataset is used in action recognition. My goal is to get the areas around the people (people are inside boxes) and do...

13 February 2021 2,538 2 View

How to increase coupling range (distance between reader and sensor coils) in LC resonance circuit?

Hello great researchers, I am working on a wireless pressure monitoring project where sensing part is actually an LC resonance sensor and I am using a planar coil as a reader to get wireless...

11 February 2021 4,148 5 View

I am looking for a microbend optical sensor design...can anyone please provide me some idea about it??

I am working on a landslide model...i need an optical sensor to determine the amount of pore pressure and other values..i am thinking of using a microbend sensor. Can anyone please provide me with...

11 February 2021 5,911 2 View

Sanat Kumar Mishra

I am sorry I couldnot understand your question properly. But may be you can try with relays I suppose.

Prasanna Waichal

Hello Sara,

Could you redefine / spell your question? What is understood from your question is you have a 220V motor but not clear whether AC or DC? Then 12V programming is what?

Y. Kebbati

Sorry, i don't understand your question. But for example, i used DTC (programmed in FPGA) to control AC motor in my phd