I am building a 3D orthomosaic of a Carboniferous coal face and I have projected it in agisoft. However, it has projected with the z-axis coordinates in reverse, I think this may be due to the camera as this is the first time that this has happened. How do you change these coordinates? Does anyone have a link to a tutorial for the coordinate system on agisoft?
I had the same issue and got no satisfactory answer from Agisoft but I did not have time to dig in either. Would be very interested to know if you find a solution.
Francois-Xavier
Have you got any further with resolving this problem? I think that it is a case of converting a geographic to mathematic coordinate system, therefore if the coordinates are converted to local datum it might work, it has worked for one of my models so far but failed with a few too!!
- Badges
- Science topic
- Similar topics
- Phytochemistry
- Extracts