Hello! I received a model of a concrete bench as a SAT file. Then i used Fusion360 to insert an infill pattern inside the concrete bench, now i want to model this in Abaqus but i can't get Abaqus to mesh the part can somebody help me? I have attached the two SAT files with an infill pattern.
Hello. I believe the following steps can help you in resolving your issue:
1. Geometry Inspection
2. Meshing Parameter Adjustment
3. Node Correction
4. Dividing the Shape into Smaller Parts
I also know a site that has good educational videos for this topic. I will give you its address, I hope it will help you.
https://caeassistant.com/product/different-techniques-for-meshing-in-abaqus/
Jarne De Vleeschauwer Unfortunately, during the geometry conversion, particularly at the edges where internal connectivity was established in your modeling, overlapping surfaces have been detected. This could lead to issues with the analysis. To resolve this, please remodel or simplify the geometry, particularly focusing on the areas highlighted in the attached mesh screenshots. While this mesh can technically be used, it's highly advisable to remove the unnecessary overlapping surfaces for optimal results. The ABAQUS algorithm may not interpret overlapping surfaces correctly, potentially leading to inaccurate analysis. If you encounter further difficulties after addressing the overlaps, please don't hesitate to reach out for assistance on my WhatsApp; Https://wa.me/+923440907874
- Badges
- Science topic
- Similar topics
- Phytochemistry
- Extracts