When I am trying to do a direct moving load analysis on a cantilever beam i am unable to see any option in the Ls-dyna environment that enables me to apply a moving load. Any suggestions?
Abhimanyu Kumar
Try contact. Look at this paper
Automated Finite Element Analysis of Complex Dynamics of Primary System Traversed by Oscillatory Subsystem
Article in International Journal for Computational Methods in Engineering Science and Mechanics 12(4):184-202 · July 2011
0 votes
0 thanks
Tirumala Koka
Try *LOAD_MOVING_PRESSURE. If you couldn't come up with any direct method of applying in LS-DYNA, then the next best solution is apply this load on a rigid body and make the body move over the cantilever surface. This will give the same effect as you are intending.
0 votes
0 thanks
- Badges
- Science topic
- Similar topics
- Engineering
- Mechanical Engineering
More Reza Razaghi's questions See All
Similar questions and discussions