I need to coat spherical silica by CN. What can be done for efficient coating?
You should use 1,3-phenylene diizocyanate
Best Regards, Leonid
I want to separate a stream of liquid and a stream of gas for an experiment. It is best suitable when the material is permeable to gases but impermeable to the liquid. Your valuable suggestions...
10 November 2019 6,591 3 View
Apart from the experimental part (where an additional problem of radiolysis (ion generation) in presence of electron beam is there) what other problems (like multiple scattering) might one face in...
10 November 2019 7,771 1 View
Nanoparticles have been synthesised by reprecipitation method and having polycrystalline character.
06 July 2017 5,325 0 View
Especially how do I interpret 2-D electronic spectra? What do the absorption and emission axes signify?
04 May 2017 3,203 2 View
Quantum mechanical description will help.
11 December 2016 2,506 0 View
It is okay even if I have to warm up the solvent a bit.
09 October 2016 4,565 3 View
Also if there are any interesting study on photonic crystals please provide the links.
08 September 2016 4,704 0 View
What does this relative intensity correspond to?
04 May 2016 3,936 6 View
Procedure should involve easily available chemicals in the lab.
02 March 2016 7,266 1 View
Please provide me with an easy procedure.
02 March 2016 8,922 0 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...
08 August 2024 2,298 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
Your comments
28 July 2024 2,822 2 View
I am trying to coating metal oxide into steel substrate, for better sticking planning to utilse epoxy based, Could you please suggest suitable curing agent for the coating purpose
25 July 2024 438 3 View
Novel areas especially
24 July 2024 8,416 0 View
I have been harvesting monocyte-derived macrophages from buffalo and cattle fresh whole blood using the same protocol for years and getting good macrophage cultures. Below is the protocol that I...
23 July 2024 4,074 2 View
I have immunized BalB/C mice with a protein using the intradermal (ID) method with Complete Freund's Adjuvant (CFA) and Incomplete Freund's Adjuvant (IFA), following a 14-day interval and three...
22 July 2024 9,160 2 View
Dear Participants- Faculty and Researchers from Pakistani Higher Education Institutions, Thank you for participating in research study that aims to 'Analyze Individual and Institutional Factors...
18 July 2024 7,024 1 View