An article on the Iranian state's civil liability in the COVID-19 matter needs supervision; Is anyone interested in collaborating?

Hello. An article on the Iranian state's civil liability in the COVID-19 issue has been written in collaboration with a friend and a comparative look at law and biology. The article is ready to be...

15 February 2021 2,906 2 View

Is it possible to report hydrodynamic loads on different parts of an ocean vehicle while 6DOF motion analysis in Ansys Fluent is running?

It seems a 6dof UDF containing vehicle characteristics such as mass and moments of inertia can be used for specifying a boundary as reprentative of ocean vehicle. It is required to have...

03 February 2021 7,726 3 View

How to determine the pH pzc (point of zero charge) for metal-organic frameworks and Organoclays?

I need to answer this question to continue my research.

12 January 2021 3,626 5 View

Detection brain abnormalities by using deep learning in python for eeg signals?

Dear Mr./Mrs. I'm going to submit my M.Sc. thesis in biomedical engineering about below subject: 1- Detection brain abnormalities by using deep learning in python for eeg signals 2- Detection...

15 November 2020 9,502 5 View

Is it possible to identify of ordered phase with x-ray diffraction technique?

I want to identify ordered phases in a high entropy alloy.

11 October 2020 5,452 4 View

How is solubility of CO2 or air in organic solvents such as xylene or cyclohexane?

For some reason, I need to inject a dispersion of an organic solvent and organoclay into a block of soil sample. the organic solvent probably is xylene.

29 September 2020 6,348 4 View

Should Quartz powder or Sand water absorption be considered for UHPC mix design calculations? How is the water absorption of the powder calculated?

07 August 2020 1,592 1 View

What is the real surface of the platinum electrode?

17 May 2020 5,493 5 View

What is the best solvent to dissolve nanoclay (montmorillonite)?

I need to inject nano-clay to some kind of collapsible soil (silty loess) to stabilize and strengthen it. I can't use water since this soil is moisture sensitive and water may dissolve the bonding...

26 March 2020 1,675 3 View

How I can eliminate 50Hz parasitic magnetic field and the at same time do not affect existed DC magnetic filed?

My application is EFNMR (Earth field nuclear magnetic resonance). In this application the earth filed, which is a DC field, has the main role and should not be altered. However, all other magnetic...

10 January 2020 337 2 View

Looking for Materials with high thermal expansion coefficient and high temperature resistance?

03 March 2021 8,272 1 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

What is the characteristic length to determine the Reynolds number for the scattered turbulent fluid flow?

Dear all, I just saw this example in FB on the difference between laminar flow and turbulent flow. The flow from a pipe hits the sink and scattered. The flow from the pipe is characterized as...

02 March 2021 1,999 5 View

What are anisotropic electrical and optical properties of a semiconductor due to?

In some materials, properties such as band gap, thermal conductivity differ along different crystallographic axes. What are the basics?

01 March 2021 1,923 3 View

Can we distinguish the type of free fluid inside the pelvic and abdominal cavities whether blood or serous fluid using the ultrasound?

during ultrasound examination of acute abdomen, sometimes we see free fluid , can we know the type of fluid ,whether blood or not , using ultrasound only? if yes , what are the sonographic...

01 March 2021 7,476 4 View

How much pressure we can reduce at the outlet to avoid Reverse Flow?

I am simulating Heat Exchanger. I have tried and tested all the methods to resolve this issue from the internet like refining mesh, improving skewness and orthogonal quality ,extending outlet to...

01 March 2021 6,985 3 View

How to show arrows over the streamlines in CFD-post?

I follow this to make streamlines like the photos attached below: (software- CFD post-processing) First I plot the 2D streamline over a surface "streamline 1". them I plot a vector by the...

01 March 2021 8,668 3 View

How to increase mesh quality of a cfd model in ansys fluent?

How can one improve mesh skewness, orthogonality, aspect ratio?

28 February 2021 7,730 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Is there a deep reason for using the squared modulus of the wave function as the probability density of the existence of the particle?

I think we were all surprised at the first time we got to know quantum mechanics that the squared modulus of the wave function is the probability density of the existence of the particle? The role...

28 February 2021 6,282 9 View