How is it possible that my GC chromatogrm for the blank run shows some concentrations?

I run GC for vfa tests and the blank run was distilled water. However, it is showing some level of concentration. Is it simply contamination or what? what should I do with my analysis-re run or what?

11 December 2019 6,123 2 View

What is a possible solution for a modified UASB that is pH around 8, full of nitrogen BUT TOO LESS METHANE?

My modified UASB is still full of nitrogen but a decreasing methane content as it is starting up. The pH remains around 8. I stopped the feed. Is it good to continue feeding or there is other...

10 November 2019 233 3 View

How much difference between COD and the Total solid in food processing industries' wastewater is acceptable?

If we analyze wastewater from the sugar industry, what difference can we expect between the total solid and COD? OR IT CAN BE ANY ORGANIC WASTE WHAT WOULD BE THE POSSIBLE CAUSE OF DISPARITY...

08 September 2019 6,934 5 View

After a reference from Int J Body Compos Res, can any body help?

Hi, I am after the reference below, my library says it cannot obtain a copy either locally or internationally, any help appreciated! Chris Wang ZM, Heshka S, Wielopolski L, Pi-Sunyer FX, Pierson...

03 March 2021 6,193 1 View

Can we block unwanted images during the x-ray prediction?

i am try to classify the x-ray images. During classification , can i block unwanted images (except x-ray image).

03 March 2021 7,100 1 View

Does anyone know to clarify these changes?

01 March 2021 1,290 2 View

In an eye with Tyndall, does each dot correspond to an individual cell?

When you observe the presence of Tyndall in an inflamed eye: Does each of the small floating dots correspond to an individual cell or to an aggregate of cells? Does a conventional slit lamp have...

27 February 2021 6,326 2 View

How to calculate the crystallinity of cellulose film?

27 February 2021 2,753 4 View

What could be the reason for not having further low chi square value (better agreement) in my refinement result?

I have tried every combination of parameter changes and after that i have a poor chi square value. I can't get it lower any further. I know there have been a lot of discussion about Rietveld...

26 February 2021 8,480 3 View

Can anyone share his experience regards Smoothing in origin?

I am working on TiO2 composite material and the results of XRD have a lot of small/junk peaks and while I apply a smooth filter in Origin then the other characteristics peaks disappear so anyone...

26 February 2021 8,183 3 View

How to replicate the well conditions of a crystal hit with 20%(w/v) isopropanol?

I had a crystal hit in a well with 0.1M HEPEs pH 7.5, 10%(w/v) PEG 4000, and 20%(w/v) isopropanol. Why is isopropanol in w/v here if it's just solvent? How do I recreate this well condition?

25 February 2021 9,761 1 View

I have need of XRD graph analysis software for phase identification. Can you please provide links for software tools which can be downloaded?

i am trying to download x'pert high score software, but can't download it. please do suggest software for phase analysis

24 February 2021 5,687 4 View

Why the CHi^2 is close to zero with a bad fitting but the Rp and Rwp are still high?

I am refining my XRD data using in FullProf program. The intensity of the modulated X-ray peaks is almost flat. I tried to adjust the peak intensities but unsuccessful. What is the reason? I guess...

23 February 2021 2,304 4 View