How can i avoid this error ?

27 April 2023 0 7K Report

Nonlinear iteration is not converging with step size reduced to hmin (3.22191e-17) at time 0.00906886. Try reducing the minimum step size and/or relax the relative error tolerance

Badges
Science topic

How does grain and grain boundary affect the ceramic when studying its dielectric properties?

I am not able to get good literature and the physics behind how first these grains and grain boundaries arises out of no where when we make a pellet to study its dielectric properties and then how...

07 August 2024 5,177 3 View

What is the ionic radius of Hydrogen anion? And how to know the exact ionic radii of the elements?

I'm trying to calculate the tolerance factors of the hydride perovskite and the value calculated by me and the reported values are contradictory. Need more clarity in using the correct ionic radii...

01 August 2024 2,614 1 View

Franklin M. Fisher (1983) Disequilibrium Foundations of Equilibrium Economics. How is it estimated now? How is it related SMD results?

Fisher studied if there is an out-of-equilibrium process that rapidly converges to some equilibrium points. He claims that Hahn process has a Lyapounof function and therefore convergent to an...

15 July 2024 1,460 4 View

Does democracy have a nonlinear effect on state capacity?

Some research indicates that the fist steps toward democratization of an authoritarian regime actually lowers state capacity. How strong is the evidence for this hypothesis?

14 July 2024 8,239 3 View

Warning: convergence tolerance of 1.000000e-06 not reached?

Hola a todos, Me gustaría realizar una consulta con relación al mensaje de advertencia que se muestra en la imagen anexada. Es un mensaje que aparece al inicializar la solución de una simulación...

05 July 2024 974 4 View

Convergence problems using opensees and specifically openseespy, what algorithm and system should i use to avoid convergence problems ?

hi im performing IDA for a 30 story consisting of bearing wall system of special shear walls for gravity and lateral resisting system , i usually face convergence problems with that , the walls...

27 June 2024 9,492 0 View

Why my mesh convergence is failing in ABAQUS?

I am doing 2D orthogonal cutting simulation in ABAQUS for aluminum. Reducing mesh size up to 0.08 mm reduces the error to 3% but further reduction leads to increase in error from 3 to 39%. Why I...

23 June 2024 9,080 0 View

What is the difference between creep deformation and stress relaxation ?

I understand the basic definition for both. I found a literature to describe both of them. In the paper, they states: If a stress is applied to a concrete body, the body experiences an elastic...

19 June 2024 525 3 View

Is asymmetric term on y-axis in zero field muSR data usually negative?

I am analyzing the zero field muSR data using kubo-Toyabe function. The fit is not converging. I am noted that the asymmetry term on y-axis is neative beyond certain time. I think this is the...

15 June 2024 2,661 0 View

Can someone introduce an article about the convergence of the temperature parameter for the SPH part in Abaqus software?

For the article, I need some references for the subject of checking the convergence of the temperature field parameter for the SPH part in Abacus, and I want to study this case with a few meshes...

13 June 2024 2,504 0 View