How can we assume the traffic and routing when calculation the energy consumption for WBSN?

11 December 2015 510 0 View

How do I calculate the radius of the bottleneck zone in WSN?

09 October 2015 9,199 4 View

What is a better distribution type for WBSN?

08 September 2015 9,223 3 View

How can represent duty cycle in Matlab?

I need to write program in Matlab to compute energy consumption for WSN. Duty cycle is very important to reduce energy.How can represent the duty cycle in Matlab?

08 September 2015 3,376 2 View

Timeout error!! Processor in the loop (PIL) using STM32F4 Matlab 2018a?

Dear Researchers I am trying to perform a PIL simulation using STM32F4 Discovery board and comunication serial USB TO TTL. During simulation I receive the following timeout error: An error...

01 March 2021 2,327 1 View

How to classify strictly upper triangular matrices by similarity?

Let F be a field. Consider U, the set of n times n strictly upper triangular matrices in F. For X, Y in U, we call them similar if there exists some S, which is non-degenerate and upper...

01 March 2021 2,957 8 View

Is CD44 degraded in lysosome together with hyaluronan after CD44 mediated endocytosis of hyaluronic acid?

Also when RHAMM binds hyaluronic acid, they get internalized, will RHAMM also be degraded? Or both CD44 and RHAMM will be transferred back to the cell membrane? Asking for breast cancer cell line...

01 March 2021 8,169 2 View

Why is the sum of the elements in a row in a Q matrix equal to zero?

When explaining substitution models, the substitutions are expressed as Q matrix. Why is the sum of the elements in a row zero?

28 February 2021 3,864 3 View

Can polymer concentrations be calculated based on the number average molecular weight?

Hello, I spin-cast two different polymers onto wafers and measure their height as a function of initial concentration. For polymer A, I have the weight-average molecular weight (Mw) as well as...

28 February 2021 7,882 2 View

Distribution of particles in metal matrix?

How would define the "good" and "poor" distribution of particles within the matrix. Is there a quantitative solution to assess the distribution of the particles, which then having denotation of...

28 February 2021 7,397 8 View

How to eliminate Steady state error from Reinforcement learning genetic algorithm code?

The following code (see 1st 2 images attached) is used to produce PID controller values that are designed to control the system (G). The code finds the PID controller values (noted as k) by using...

28 February 2021 6,560 14 View

How to find a correlation between coordinates in a curvilinear coordinate system?

Hello. I have a skewed elliptical coordinate system (I use alternative elliptical coordinates). And I need to determine connections between coordinates in order to fetch a covariance matrix of...

28 February 2021 364 3 View

How to prevent ANFIS Model from negative prediction values in MATLAB?

I have input and output data set for "ANFIS modeling in MATLAB", and I am getting some negative predicted values of output in testing. However, the predicted values of output in training are...

28 February 2021 3,459 3 View

For modelling epoxy-based matrices (in composites), which model in ABAQUS is the most suitable, Concrete damaged plasticity or Drucker-Prager model?

I am working on developing a micromechanical FE model for predicting kink-band formation in UD composites. To model matrix plasticity, which model, out of Concrete Damaged Plasticity and...

28 February 2021 5,415 1 View