How can DMF (dimethylformamide) removed from the structure of a polymer compound?

07 June 2023 1 3K Report

How to remove DMF (dimethylformamide) from the structure of a polymer compound without using a vacuum oven?

In some cases just drying in ventilation laboratory hood with small heating can be work out. But be carreful becasue DMF is highly inflammable liquid and ventilation should be ON during heating even at small temperatures.

Badges
Science topic

More Fatemeh Moghaddam's questions See All

Which type of compound does lamda max of 218 indicate in a uv-vis spectrum of a partially purified compound through column and TLC?

A crude extract of fungal culture using EtOH was subjected to column and TLC and partially purified compound was obtained. UV vis spectrum of the compound/s has max absorbance at 218nm. The...

11 August 2024 9,801 2 View

Conjugation of PEG-Amine to an Amino Acid Using EDC?

I am attempting to conjugate PEG to an amino acid at the C-terminus, for the purposes of producing nanoparticles. I have been told that PEG modified with amine groups can be used for this purpose,...

31 July 2024 2,033 1 View

Does soybean seed coat or cotyledon contain chlorophyl or flavonoids? What types? determined by paper chromatography? other methods (high school lab)?

Am trying to develop a lesson/lab to determine and compare antioxidant properties of soybeans of various colors. Preference would be low tech and low cost. Any assistance is greatly appreciated.

25 July 2024 7,498 2 View

Does post-translational protein modification cause devisions on observed pI verses calculated pI?

In running two-dimensional gel electrophoresis on bacterial protein, some spots that appear to match a protein sequence have a significantly more acidic isoelectric point than the calculated pI....

24 July 2024 8,076 3 View

How I can add anew research in my account ?

Their is new research published in the biological control journal, and I am one of the authors. I want to add it to my account at researchgare. How can I do this?

21 July 2024 7,545 0 View

Can Document Analysis be used as the only method of research?

I have read that it is better to use other research methods alongside document analysis for triangulation, although it can also be used as a stand-alone method.

18 July 2024 4,218 0 View

How much sample we are required to do a pilot study for standardized an Achievement Test?

I am conducting a study on Effectiveness of e-content on academic achievement of secondary school science student.

17 July 2024 5,633 4 View

Masonry Interaction Module ABAQUS?

I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...

16 July 2024 5,047 0 View

What is wrong with my input file?

im studing gaussian 16 with reading paper about I-131 Metaiodobenzylguanidine in the paper "In a similar vein, nuclear magnetic resonance shielding values were investigated using the widely...

16 July 2024 6,040 4 View

Can ROBINS-I be used to measure risk of bias in single-arm studies?

I am doing a systematic review, and I am measuring risk of bias with RoB2 for RCT, and ROBINS-I for non RCT. My questions is, for single arm studies, can I use ROBINS-I? I am not sure how to...

14 July 2024 3,570 5 View

Can we isolate microplastic from sludge sample without using vacuum filter..?

isolation of microplastic from sludge sample using centrifugation ..

23 July 2024 6,418 0 View

Is it possible to manufacture polypropylene sheets using a biaxial process?

I know that films and other low-thickness laminated products are produced using biaxial orientation, but is there something similar for sheets with a thickness of around 6 mm? Or are they...

21 July 2024 1,559 1 View

Why does total carboydrate content decrease when increasing the vacuum degree?

I have conducted a survey on the "effect of vacuum drying conditions on carbohydrate content of angelica.S". The result show that, when increasing the vacuum degree, the carbohydrate content first...

13 July 2024 592 1 View

Why am I seeing only one initial maximum in torque-time curves for the fusion of PVC in a Brabender?

We're studying the stability and fusion behavior of multiple PVC compounds in a Brabender. After a few trials, we set the temperature at 195 °C and the rotor speed at 70 rpm. Samples differ in...

12 July 2024 2,768 1 View

Can vacuum cleaners spontaneously explode?

We assume that vacuum cleaners can explode spontaneously. Very few catastrophic accidents due to vacuum cleaner explosions have occurred in the world recently. We also assume that the mechanism or...

03 July 2024 4,846 2 View

Can a vacuum explode spontaneously?

Whether a vacuum can spontaneously explode is a serious question that essentially falls under quantum mechanics. If the vacuum can explode spontaneously, this would mean that the dynamics of the...

27 June 2024 2,047 2 View

What does the area under the curve signify in dielectric loss tangent studies for solid polymer electrolyte ?

In solid ceramic electrolyte what is the Physical significant of area under the curve in dielectric loss tangent studies ??

23 June 2024 4,354 1 View

How do you explain the formation and explosion of the Big Bang?

Before the Big Bang, there was space and time that constituted unitary four dimensional vacuum. This problem belongs to quantum mechanics and can be solved by quantum matrix sequences from the...

14 June 2024 2,631 11 View

Can anyone explain how mobile ions moves inside ploymer electrolytes?

I want to know the exact mechanism behind the motion of ions inside the polymer electrolytes.

13 June 2024 3,489 0 View

What is the breakdown voltage/dielectric strength of Polyvinyl Alcohol?

I searched everywhere and I can't find a single definitive source, the only paper that I found was this one:...

12 June 2024 3,126 3 View