I have found EPOON 1004F epoxy resin with good viscosity, but I am not sure how to use it. Could you please tell me how to use EPOON 1004F epoxy resin before? Thank you very much.
Address of attached materials:
https://www.sohu.com/a/464628472_120008557
Dear Shi Yu Yang,
I visited the link you send but everything was in not arabic characters, so I was unable to understand the information. Nevertheless, I can explain you how I use to work in order to embed something in epoxy resin. Depending on the viscosity on the resin actually. The main idea is to dissolve the epoxy in a low-boiling temperature solvent (dichloromethane is an option) to obtain a viscous liquid. Then you embed whatever you need to embed (in this case, microspheres), and after that, the only thing to do is to evaporate the solvent, for example with vacuum or some heat. If you use dichloromethane, with 40ºC is enough. Then you have your spheres embedded with your epoxy resin.
At this point, this should be enough for what you asked for. Remember only that epoxy resins need a crosslinker. Usually, these are added once you want to crosslink, and diamines are the most common.
Hope it helps! Best of luck!
- Badges
- Science topic
- Similar topics
- Physical Sciences
- Materials Science
- Materials
- Carbon Materials
- Graphite
- Graphene