Both were found on a vessel hull among other macrofouling organisms.
Location : Sri Lanka
How to build fouling and erosion simulation model for Aero Engine compressor and turbine rotor in Simulink / Matlab?
22 February 2021 3,697 1 View
I am an undergraduate student at the University of Peradeniya Sri Lanka, currently working on ecto-parasites in domesticated animals. I found difficulties in the identification due to a lack of a...
15 February 2021 277 1 View
I modified PES membranes with nanoparticles (nanosilver, graphene, halloysite). They were used in UF for WWTP effluent treatment. After filtration, all membranes exhibited more negative zeta...
26 December 2020 5,676 3 View
I need to calculate CFR based on age group and sex. For this, I need daily COVID-19 confirmed cases and deaths according to age and sex for Sri Lanka. Where can I find this?
13 December 2020 8,287 2 View
I am currently working with a dead-end ultrafiltration system with constant flux rate. The schematic of the experimental system used for constant flux experiment is shown in the figure attached....
06 December 2020 3,002 3 View
We are working on ultra-filtration of a liquid waste but there are some problems with membrane fouling. Do you have any suggestions of suitable pre-treatments for a sample with high concentration...
19 November 2020 2,122 6 View
SDI indicates the fouling tendency of membrane. Is there a possibility to relate the TOC of saline water to SDI so as to measure indirectly the fouling tendency of membrane in RO desalination...
20 October 2020 8,311 4 View
I am currently working on the design of a 1-shell, 4-tube pass heat exchanger with 200 copper tubes. The purpose of the problem is to determine the affects of fouling on heat exchange area. Unused...
19 May 2020 7,431 7 View
I currently work on analyzing fouling rate in BFB biomass boiler, based on available measurements. Looking through literature, the only reported values I found were from certain TEMA Tables, from...
19 April 2020 1,973 5 View
Dear researchers, I have some salt solution analysis. I want to know is there any software to estimate the scale deposition thickness in a specific time period on a metal plate at a known...
24 March 2020 1,396 3 View