HF behaves as a base?

07 July 2015 0 2K Report

HF behaves as a base in which of the following solvents? A. NH3 (l) B. H2O (l) C. CH3COOH (l) D. H2SO4 (l) E. Aqueous 0.10 M NaOH F. None of above

Badges
Science topic

Similar topics
Chemistry
Chemicals
Solvents

More Mohanad Halboos's questions See All

How can calculate intra day and inter day precision?

31 December 2018 1,841 0 View

How can analysis partial least square by using spss software?

06 July 2018 6,287 2 View

In Flow Injection technique, why the slope of calibration curve do not pass through the zero point?

When you draw a calibration curve is always the slope is higher than the original point at its intersection with the y-axis, with the knowledge that the solution used is blank solution.and when to...

04 May 2016 4,855 3 View

What will the change in peak width (w) be if the column length is triplet in chromatography?

What relationship between peak width and length of column in chromatography?

03 April 2016 1,366 0 View

Van Deemter equation?

The theoretical plate numbers for a gas chromatography system are found to 55.3, 96.9 and 89.8 for linear carrier gas velocities of 0.55, 1.65 and 3.10 cm\sec respectively. Calculate the maximum...

03 April 2016 9,166 3 View

How is the choice of the analytical method of Instrumental analysis in analytical chemistry in general?

In general on what basis are chosen analytical method?

02 March 2016 7,236 9 View

Why the slope of calibration curve do not pass through the zero point?

When you draw a calibration curve is always the slope is higher than the original point at its intersection with the y-axis, with the knowledge that the solution used is blank solution.and when to...

02 March 2016 5,607 4 View

How can I reduce the amount of noise in the detector?

If the signal affected by noise generated on the detector and thus affect the calibration curve in analytical chemistry method. How can I reduce them?

02 March 2016 8,567 4 View

What is the best way to write the cover letter?

What is the best way to write the cover letter for journals of Thomson Reuters?

04 May 2015 3,075 6 View

What is the solvent for 8YSZ nano material?

I need to do some experiment with it in liquid form.

07 August 2024 613 3 View

Which solvent is better to dissolve with secondary metabolites extracted from fungi?

I work on MCF7 cell cell for anticaner purpose and I wa to do drug preperation the drug ( secondary metabolites extracted from Aspergillus) My question which solvent is better with these secodary...

03 August 2024 4,725 2 View

I need to dissolve stigmasterol for an animal experiment, it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent?

Hello everyone, I need to dissolve stigmasterol for an animal experiment, but it hasn't dissolved in either DMSO or vegetable oil. Can anyone recommend the best solvent for stigmasterol?

01 August 2024 7,504 2 View

Why methanol and sulphuric acid used in the analysis of polyhydroxyalkanoates (PHA) by GC-MS?

Why methanol and sulphuric acid, used in the analysis of polyhydroxyalkanoates (PHA) methyl esters by GC-MS? Additionally, why do we typically use non-polar solvents in GC-MS?

22 July 2024 1,210 2 View

When making abraxane with Nab tech, why is 9:1 Chloroform&EtOH used as solvents?

Is it the best optimization ratio based on experiments?

22 July 2024 8,170 0 View

What is the solvent system required to run tlc for calixarenes?

If you don't understand my question let me know

21 July 2024 563 1 View

Convergence of absorbency values to determine the total phenolic content of several solvents?

I used several solvents and measured the absorbency and determined the total phenolic content, but the results were similar after dropping them on the titration curve; What is the reason, please help

17 July 2024 5,151 5 View

How Can I Resolve a Persistent Unwanted NMR Peak at 1.25 ppm?

Hello everyone, I am facing a consistent issue in my NMR spectra with an unwanted peak appearing at 1.25 ppm. This peak seems to vary with the amount of sample: it becomes more pronounced with...

15 July 2024 9,065 4 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

15 July 2024 2,414 1 View

Hey there, What is The best recommended solvent( safe for use) to dissolve or remove Z-90 Adhesive from ceramic surfaces ?

as of my knowledge z90 is acrylic based sealant adhesive.

09 July 2024 8,660 4 View