For calculating antioxidant activity through the DPPH method, should be plot the graph between absorbance and concentration or % inhibition and Conc?

08 August 2018 1 10K Report

Graph should be plotted between absorbance and conc or % inhibition and conc.

hello,

if you ask about results expression its up to you.

for DPPH method it will be helpful to express your result as % inhibition or IC50 in order to be comparable to the literature review.

Badges
Science topic

Similar topics
Mathematical Sciences
Graphs

More Rashmi Tripathi's questions See All

The standard quercitin on TLC plate is showing two spots one at the point of origin and one on top.Why is standard showing two spots?

the same standard run in methanol showing single spot.

07 August 2019 6,296 6 View

I have performed tissue biochemistry in Clarius against flouriode toxicity. What is the standard value for the parameters such as ALT AST ?

How to compare my results for the parameters AST/ALT, ALP, LDH, GGT, Serum albumin , bilirubin

01 February 2019 3,978 2 View

can anyone suggest me caspase protocol by ELISA method?

Wanted to perform caspase test so required the protocol

04 May 2018 1,925 0 View

How can I calculate IC50 in DPPH test by using graph pad prism software?

How can I calculate IC50 in the DPPH test using graph pad prism software? or suggest a manual method and other software to calculate the IC50 value.

06 August 2024 8,848 3 View

What is meant by baseline of FTIR data?

I got comment on my FTIR data figure from a reviewer. The reviewer said "FTIR data in Figure should be repeated. there is no bassline." I made Y off set comparison graph of FTIR on OriginLab. Can...

03 August 2024 6,070 3 View

Is the mentioned CV graph a valid one as this graph have only one peak prominent (reduction)?

I have used Prussian blue nanoparticles as a redox couple. The PBNPs have been made using only one salt precursor. Also, during scan rate studies, a small oxidation peak can be consistently found...

31 July 2024 9,697 0 View

Entropy measure and QSPR modeling in Graph Theor. How to construct the table for lengthy equation?

The entropy measured of molecular graphs plays a crucial rule. The network structures in some cases are very lengthy calculations to handle. Some author avoid to construct table where as most...

30 July 2024 3,126 0 View

There is possible way to calculate experimental DOS from the UPS spectrum of the material. How to calculate the DOS from UPS?

Here, I have attached the UPS graph. I'm trying to calculate the DOS/DOVS from the UPS.

29 July 2024 4,971 1 View

Does the gender of plants affect in the level of DPPH?

I have conducted research on the genus Salix, ad my results show that gender has a direct impact on the DPPH. Has anyone else obtained similar results or do you know of any articles that confirm this?

27 July 2024 5,144 1 View

Critique Calculaltion in Topological Indices and QSPR Modeling?

The first step is to analyze a 2D molecular graph and implement partitioning techniques to calculate the topological indices. Secondly impose statically tools to generate QSPR model, may or may...

24 July 2024 9,644 1 View

How to do calculation of Louvain methods calculation for excel sheet and and is there any software available?

The Louvain method – named after the University of Louvain where Blondel et al. developed the algorithm – finds communities by optimizing modularity locally for every node’s neighborhood, then...

23 July 2024 6,659 0 View

Is there a name for this type of function?

Let n∈ℕ, where the function f:A⊆ℝ𝑛→ℝ, 𝐴 is Borel, and (A,d) is a completely seperable space. What is the name of the functions where the graph of f in any (n+1)-dimensional box of A×ℝ is...

17 July 2024 258 1 View

Why is linearity somewhat lost when plotting the Stern-Volmer (SV) graph?

When preparing a graph of fluorophore intensity vs. analyte concentration, the linearity shows an R² of 0.999. However, when plotting the same data as Fo/F vs. analyte concentration, the linearity...

13 July 2024 7,131 0 View