For both the light and heat sensitive product, could anyone suggest a better heating technique towards removing the solvent from the mixture?

More Nushrat Yeasmen's questions See All

How to conduct recovery study of organic pollutants in river sediment/ soil/dust samples?

Hello, Greetings. I would like to measure the recovery percentage of the organic pollutants by spiking the samples with certain working standard concentrations. My samples were air dried and...

13 August 2023 4,968 2 View

How to explore normality test for organic pollutant when I have two seasons and 9 sampling points?

Hi there, I am currently analyzing 6 PCB congeners (Polychlorinated Biphenyls) in the river sediments. I am using SPSS for data analysis. I don't quite understand how to explore normality...

10 November 2021 314 3 View

Difference between Collagenase type-2 and Collagenase type-3?

Previously I used Worthington Collagenase type-2 for mouse dermal fibroblast isolation. Can I use Collagenase type-3 of the same brand for the same protocol? Did anyone face a problem with...

22 August 2021 7,056 3 View

How to interpret Shapiro Wilk test conducted for PCBs data analysis in river sediments with .000 sig. values?

Hi, I am investigating 6 PCB (Polychlorinated Biphenyl) congeners in sediments from 9 locations from the river bank for two seasons (pre-monsoon and post-monsoon). I have carried out Shapiro Wilk...

13 August 2021 795 10 View

What is the probable cause behind advection diffusion solution instability in HEC-RAS temperature model?

While running temperature model in HEC-RAS, my model went unstable due to advection diffusion calculation instability. HEC-RAS uses QUICKEST-ULTIMATE scheme for water quality modelling. Can anyone...

14 January 2018 2,058 5 View

How can someone avoid citing a research paper published in a predatory journal?

I have observed recently that some research papers published in predatory journals are available in google scholar. So, while searching for a research article in a particular topic, one can come...

01 January 1970 2,680 5 View

Controlling for pupil light reflex when analyzing pupil size time course?

I used eye tracking to examine how participants from two different populations (A and B) react to an image. Participants in population A exhibit larger pupil sizes over time, but they also have...

10 August 2024 3,229 0 View

How to fix errors in my heat transfer steel structure with reinforced concrete slab model Abaqus?

I have modelled a steel structure using beam elements in Abaqus and attached to this structure reinforced concrete slab. The analysis that I am making is heat transfer of the structure. The...

07 August 2024 1,028 0 View

Why does my protein refolded to beta sheet during thermal denaturation analysis?

Hi! So i attempted to understand a novel protein behavior towards heat application by analyzing its secondary structure change. I subjected the protein to a thermal denaturation analysis using...

06 August 2024 1,989 3 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

What should I do with parameters that are not relate to my simulation in MyLake model?

I want to Estimate surface heat fluxes using MyLake, but I don't have all the initial values in model parameters section and other sections,is there a way?

04 August 2024 1,537 1 View

Z-average size from Dynamic Light scattering can it be lower than the original probe size?

Hi everyone, Recently I have been conducting Dynamic Light scattering experiments in a micellar solution at 5 and gel at 37 degrees of Celsius with latex particles of diameter 190-500 nm. While...

01 August 2024 1,168 4 View

What should be the sample container for the hydrothermal reaction in a microwave reactor at 180 °C for 10 min at the heating rate of 5 °C per minute?

Suggest one of them 1. Teflon-lined stainless steel autoclave: 2. Alumina (Al2O3) ceramic container

30 July 2024 7,326 1 View

While doing Chronoamperometry, when the light is turned off, why the current is not decreasing sharply?

Here, I have used Ag/AgCl as reference electrode and 0.5M KOH.

29 July 2024 4,538 3 View

What are the perfect mathematical model for a solar-powered ship implementation?

A computational study of heat flux on cylindrical surfaces using CNT hybrid nanofluids

28 July 2024 4,985 1 View

Seeking recommendations for equipment to mimic sunlight and heat up a greenhouse system?m?

I would like to conduct artificial sunlight experiments to mimic heat capture and air warming in a greenhouse system. The main objective is to heat up the temperature inside the greenhouse, not...

28 July 2024 4,006 2 View

Gamal B. Abdelaziz

Evaporation, distillation and Chromatography

Also Filtration, Fractional distillation and Magnetism can be used. But in case of removing the solvent from the mixture Evaporation or distillation are preferred

Nushrat Yeasmen

Thank you so much Gamal B. Abdelaziz , distillation sounds good to me, would go for that may be.

Dear Nushrat Yeasmen

With the aid of the following link you can go and use the references on the end of the page in the link

https://www.thoughtco.com/what-is-distillation-601964