Finfet small signal model?

Manoj KUMAR Parida @Manoj_Parida2

11 November 2014 1 670 Report

How to perform small signal analysis for FinFET?

Satyabrata Sarangi

Dear Manoj,

These articles may help you.

http://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=6188936

http://www.jsts.org/html/journal/journal_files/2010/06/year2010volume10_02_09.pdf

http://www.sciencedirect.com/science/article/pii/S0038110107003152

Good luck.

Badges
Science topic

Similar topics
Philosophy Of Science
Models

More Manoj KUMAR Parida's questions See All

Cross section of Uranium-238 at different fast energies of neutron?

Dear All, The neutron cross section of element generally falls with the increase in neutron energy. But in U-238 the fission cross section at Neutron energy of 1MeV is 0.3 barns whereas it...

02 March 2017 1,774 4 View

Ideality factor for diodes?

Is there any mathematical formula there for the ideality factor of the diodes? I will be very much thankful for the above. Please send the mathematical expression for it.

08 September 2016 7,007 5 View

The pulse shaping circuit of the radiation detector?

In the radiation detector the pulse shaping circuit consists of CR-RC circuit and amplifier.The function of pulse shaping amplifier is to improve Signal to Noise ratio.It also act as a filter to...

08 September 2016 8,565 4 View

How to reduce shot noise in the semiconductor radiation detector?

Generally there are three types of noise is present in the semiconductor radiation detector.These are Thermal Noise,Shot noise and Flicker Noise.The thermal noise is removed by operating the...

08 September 2016 9,355 2 View

Coating of Enriched Boon-10 on Si Surface other than CVD technique?

Dear All, Is there any technique other than the CVD to coat the Enriched Boron-10 on the Si surface? I will be very much thankful for the reply. Thanks & Regards Manoj

08 September 2016 8,686 0 View

In radiation detector Generally the HV Bias to the detector is given through the charge sensitive Preamplifier?

In the commercial available charge sensitive preamplifier for semiconductor radiation detector.Generally the HV(High Voltage) bias given to the semiconductor detector is through the charge...

08 September 2016 4,154 4 View

Neutron irradiation effect on semiconductor PIN Diode?

I have performed the neutron irradiation on the PIN Diode. I have found that the forward bias cut-in volatge has been shifted. Why these shift been observed in the neutron irradiated PIN...

06 July 2016 8,002 3 View

Why electric field is maximum at the center of the depletion region in the PN junction?

In the depletion region only uncovered ions are exiting then why we have the maximum electric field at the center of the junction?

06 July 2016 7,472 6 View

How does a guard ring in the PIN Diodes reduces the surface leakage current?

The function of the Guard ring is to reduce the leakage current and make the PIN diode to work at higher potential ? How does the guard ring perform this function? Please some one explain...

06 July 2016 6,690 2 View

Common mode signal calaculation?

Dear All, For the common mode signal the input voltage is calculated as (V1+V2)/2. Why we are calculating the common mode input signal as (V1+V2)/2 whereas in differential mode the input signal is...

04 May 2016 2,090 1 View

How to learn more about SPSS and its Application?

I would like to learn more about SPSS and Its application especially in regards to data analysis. Please suggest me how I can learn more about it. Thank you so much.

11 August 2024 9,101 4 View

Can I base on reverse DNA sequences to perform alignment, convert to amino acids and GenBank submission?

I have reverse sequences (AB1 format), can I base on reverse DNA sequences to perform nucleotide alignment, convert nucleotides to amino acids and deposit the sequence in GenBank database?

11 August 2024 5,138 1 View

Can you connect an HPLC to a Mass Spec only at a certain time point?

Can anyone explain this method? Especially the last statement where it says only at 1.5 to 2.5mins was the MS/MS connected to the UPLC. How is that possible, is it a feature in this specific...

11 August 2024 8,141 3 View

Baseline drift in HPLC? What causes this?

Hello, Why do i see this baseline drift when i compare my blank (black) to the sample (blue)? Any suggestions as to why this happened? Thank you!

11 August 2024 3,770 4 View

Text-Communication from the M1 Hand Area using BCI—and then there is Elon Musk?

Willett, Shenoy et al. (2021) have developed a brain computer interface (BCI) that used neural signal collected from the hand area of the motor cortex (area M1) of a paralyzed patient. The...

10 August 2024 7,180 0 View

Has anyone applied Python in the field of textile engineering for data analysis, automation, or smart textiles?

I'm currently exploring the application of Python in textile engineering, specifically in areas like data analysis, process automation, and the development of smart textiles. I'm interested in...

10 August 2024 7,429 2 View

How can I use the cif data obtained from rietveld refinement extracted via gsas2, for microstructural analysis using ETEX software?

09 August 2024 7,718 0 View

How are iso-frequency contours plotted?

Let's say we have a standard, regular hexagonal honeycomb with a 3-arm primitive unit cell (something like the figure attached; the figure is only representative and not drawn to scale). The...

07 August 2024 1,937 1 View

How to prepare the nanoparticle treated fungal sample for Environmental SEM analysis?

A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.

07 August 2024 5,307 1 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View