Hello everyone, and thank you in advance for reading/answering my question.
I have built my gelogical model in PETREL software exported it into Rescue format and imported it into CMG Builder, to this point there was no error and the check mark in builder turned green.
After that, I finished my Pvt model in CMG Winprop and exported a GEM file to use it in Buidler, when I imported the data the following Error appeared in the reservoir tab and I didn't know what is the problem. (See attached picture)
Does anyone know what is this problem and how to fix it?
Thank you again for the help
It is a very very long time since I did this with the tools you are using but guess estimating a lot I would throw the wild hypothesis that you have not yet mapped the PVT properties to regions.
- Badges
- Science topic
- Similar topics
- Computer Science
- Program