29 August 2022 0 5K Report

Hallo,

i did a nanoindentation on an implanted CAR and i found that when the CAR has a thicker layer, then it is less hard. Does anyone know why??

thank you very much!!!

best regards

chiko

More Mokhtar Sidi Salah's questions See All
MAGeCK Plotting Error: Logarithmic Axis Must Have Positive Limits?

I have been running a MAGeCK test command on the terminal for a CRISPR screen to rank sgRNAs and genes based on the read count tables. However, I get only the plot of the top-ranked genes...

28 July 2024 9,811 1 View

Getting small dark current when simulating the Photovoltaic device Using the SCAPS-1D?

When I simulate the solar cell or self-power photodetector in SCAPS-1D, I optimize all parameters, Once I check the dark current at 0 voltage, the current is high in a range of (e-16-e-25), as...

06 July 2024 1,782 3 View

How to calculate Capacity retention for Lithium metal battery?

I have prepared half cell. Lithium is considered as anode in the system. Whereas, I would like to know what is actually capacity retention? How it can be calculated mathematically? On what factors...

02 June 2024 4,135 0 View

MANOVA for IV and DV catergorical data?

Hi everyone, I would like to know if there is any analysis by MANOVA for the categorical data of IV and DV. How is the step to running?

20 May 2024 4,066 1 View

Is there a free trial of the SILVACO TCAD ?

I wan to simulate the 2D Photodetector

22 April 2024 8,756 0 View

Is there a company known that can design an electrode shadow mask for photodetector ?

I want to design electrode shadow masks for photodetectors .The shadow mask can be made from uncontaminated materials. We do not have lithography fabrication at my university, so i want to design...

12 April 2024 2,312 3 View

What is the reason that a Li-ion coin cell is not showing efficiency on neware battery testing system?

I have been working on electrospun membrane for Lithium Ion coin cells. I have tried to control different parameters, such as, thickness, electrolyte amount and many other parameters. I am facing...

26 March 2024 2,786 0 View

Is this journal legitimate (Tobacco Regulatory Science ISSN: 2333-9748 ) ?

I'm considering submitting a manuscript to this journal (Tobacco Regulatory Science ISSN: 2333-9748 ) Has anyone published in this journal before? I am looking to confirm that this journal is...

05 March 2024 4,144 1 View

What is the agricultural area using center-pivot irrigation in Egypt and how many center-pivot irrigation devices are there?

area using center-pivot irrigation in Egypt Number of center-pivot irrigation devices

16 February 2024 1,376 0 View

Is there absolute truth in marketing?

From the perspective of epistemology, is there absolute truth in marketing?

02 February 2024 9,182 6 View

Similar questions and discussions
Can formaldehyd-fixed gelatin be melt?

I am puzzled about the properties of gelatin, when used for tissue-embedding. Hard gelatin can be melt again by temperatures about 40°C. Formalin-fixed gelatin is like crosslinked protein and...

07 August 2024 1,686 1 View

Why activated CAR-Jurkat cell could not kill targets?

Previously when I co-coluture anti-CD19(FMC63) CAR-Jurkat with Raji with E:T=5:1, Jurkat can eliminate Raji in 24h. However, when I test another CAR construct, although I can dectect totally CD69...

06 August 2024 641 2 View

Why am I getting "shark finn"-like signal?

My collegue and I are having hard time to understand what is happening. Basically we have a tapping device that work with Arduino and a pneumatic pump. The pump allows the tapping of two...

04 August 2024 4,662 1 View

In SEM, if a latent variable consists of three observed variables, and each observed variable has four items, what should I do?

Suppose I am studying the construct of "Academic Motivation" (latent variable) in students, which is measured through three observed variables: "Intrinsic Motivation," "Extrinsic Motivation," and...

31 July 2024 3,913 6 View

Mechanochemistry: ball to powder mass or ball to powder volume?

I run mechanochemical reactions that involves the use of a large amount of catalyst (1:1 molar ratio to the reactant). When I try to understand the effect of amount of catalyst on the reaction, I...

23 July 2024 9,938 1 View

What are the current challenges and future prospects of integrating artificial intelligence into recognition systems for autonomous vehicles?

This question aims to explore the intersection of artificial intelligence and autonomous vehicle technology. It seeks to identify the key challenges faced in implementing AI for recognition...

20 July 2024 3,469 2 View

Hellow every one i have a question, please help me. How ESP car working?

I try to understand the ESP mechanism working. What kind of sensors it has, Is it necessary to modify or boost its mechanical ?

15 July 2024 4,772 1 View

Do you know about fully Ethanol toyata Inova car?

https://youtu.be/5MckkqF9XWU?si=MvBsElJZg8_At8qP

09 July 2024 6,038 5 View

How can we effectively assess and monitor the health of the soft and hard tissues around implants so that problems can be detected and treated early?

Although I have extensive experience in dental implants and periodontal treatment, I recognize that we face some deficiencies in my clinic. First, we need to update our equipment, especially in...

09 July 2024 2,004 3 View

What's the use of buying temporary things?

I would like to know why do people buy temporary things like cars, houses, land, animals etc. when they cannot have it permanently after they die?

05 July 2024 2,715 4 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close