During the improvement of Crude tire pyrolysis oil, the distillation is carried out between (150-200) oC. Why use 150-200) oC?

07 July 2016 0 8K Report

The distillation is carried out between (150-200) oC. Why use 150-200) oC? How about the oil obtained at other temperature ranges ?

Badges
Science topic

More Md. Rafsan Nahian's questions See All

Boundary conditions of steady flow over a circular cylinder in Ansys Fluent?

Hi, I am trying to simulate the steady flow on the wake of a circular cylinder to find the optimum Turbulence model for different Reynolds numbers. However, in most of the research papers I found...

09 October 2018 481 5 View

Can you suggest me some medium to high rank journal (no article processing charge) relating to fluid properties and sensing instruments?

I want to publish an article related to measurement of fluid properties using sensing instruments. Therefore, I am looking for a journal (medium to high rank) which has no article processing...

10 November 2017 8,398 2 View

Image Processing in Python?

If anyone wants to learn image processing, which software will be the best? Is it can be done through Python? I appreciate your valuable suggestions.

09 October 2017 7,243 5 View

What type of pressure is measured by piezoelectric sensor in the delivery side of a centrifugal pump?

Suggest the theoretical principle of pressure measurement at any point in the delivery side of a pump. What type of pressure is it? If a piezoelectric pressure sensor is used to measure pressure...

07 August 2016 8,571 3 View

Aspen Plus Simulation?

Greetings When one is to perform Simulation or modelling of Pyrolysis of Biomass Waste materials using Aspen Plus software, and one has both the macromolecules breakdown (Cellulose, Lignin and...

06 August 2024 5,023 1 View

RNA later for the preservation of RNA in fecal samples at room temperature for one day (37°C)?

I am planning to collect human fecal samples for metatranscriptomic analysis using MGI. These samples are from indigenous people living in a region with high temperatures. I will have access to a...

06 August 2024 1,367 3 View

How to understand this crystallographic phenomenon of low temperature crystals in zeolite?

During low-temperature testing, new diffraction peaks that appear could be indicative of several phenomena. In one of our tests, we observed notable new peaks around 40° and 45° in a specific...

06 August 2024 726 3 View

How to heat polymer for about 130° without oil bath ?

is there any other way to heat a polymer evenly other than oil bath if so what are those and how to use it

06 August 2024 947 1 View

Do you think can be any gas and oil bearing rocks in Eastern part of Iran?

I want to know more about petroleum deposits in Iran.

02 August 2024 8,725 3 View

Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Heavy Crude oil PVT Data?

Hello i need heavy oil PVT data having viscoisty of 2000-3000 cP. If someone have it or research papers about it, kindly share it with me Thanks

25 July 2024 6,940 1 View

What are the most PROBLEMS of HYBRID nanofluid in oil industry ?

explain your idea

23 July 2024 1,197 0 View

Why my gel electrophoresis has smearing?

Greetings. I’m currently running a nested pcr for giardia. My mastermix comprised of 3mM Mgcl2, 5unit of taq polymerase, 0.2uM of forward and reverse primers each respectively and 0.2mM of dNtp...

22 July 2024 9,761 5 View

VOC analysis on GCMS ?

Hi everyone, Can someone explain for me a method to inject VOC collected with Tedlar bag from pyrolysis process and transfer or inject into GCMS. Thanks

22 July 2024 6,398 1 View