I am solving a problem using Two physics Shell, Shell 2 (I applied shell to particular region, Shell 2 to remaining) , Comsol Solver is Solving Two physics separately and it is showing results separately for two physics that means it is splitting the model, I would like to know how to link those two physics such that entire body will be solved as single.
hi rayudu ,
You are bit confuse about comsol actually its true that comsol solve simultaneous more than one physic but its depend on you which physic is important in your area of interest and if you going to deal for a single phyisc then you can go with it & it would suggest you please go through comsol manual and try to know more about comsol that will increase your understanding because going blindly is not worthy so understanding is more important whenever you are going to use any software packages.
good luck
Hi!
You must control in the respective physical properties this condition, and here recall the desired link.
e.g. in a coupled heat transfer and CFD model, CFD condition for temperature must be the same name for heat transfer model. Following my example You can find this condition in the CFD "fluid property" and select "Temperature (ht)" .....
Rayudu,
If you would like Comsol to solve the two problems separately, but you would like to see the two postprocessed results on the same 3D/2D Plot Group (simultaneously show both results), you only need to define two identical plot types (e.g. Surface Plot for 2D models or Volume Plot for 3D models) under the same plot group and select for each of these the corresponding data set (e.g. Solution 1 for the first problem and Solution 2 for the second one). This is available only in the 4.0+ versions of Comsol.
- Badges
- Science topic
- Similar topics
- Engineering
- Mechanical Engineering