What optical, magnetic, resistive material relationship do I have in my materials?

02 March 2015 8,846 5 View

If there is more oxygen functional group means, is the conductivity of the material low or high?

I have literature review of the article which there long discuss of the materials have functional group, have conductivity of the materials I must know.. whether the materials have conductivity is...

07 August 2014 5,708 3 View

How we say the sulfer materials used as reduced agent in graphene oxide?

I have worked with graphene nanocomposite and here the sample sulfer is used to reduced of graphene oxide (the papers). I have doubts about how its reduced and get good conducting nature?

04 May 2014 6,236 1 View

How do I know what has a high electric conductivity?

I have doubts about graphene conductivity. Which has more high conductivity G, GO, or rGO?

03 April 2014 2,377 4 View

How does the recombination rate behave in solar cell applications?

I have prepared the semiconducting material for solar cell applications, and I need to calculate the recombination rate and the lifetime of solar cells devices.

02 March 2014 9,097 4 View

Why does blocking with my immunogenic peptide cause nuclear fluorescence in ICC?

Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...

03 March 2021 5,999 3 View

Irradiation data for JAPAN?

Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...

03 March 2021 961 3 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Does Napabucasin soluble in dichloromethane and in ethanol?

I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...

02 March 2021 9,945 3 View

Help request in CST microwave?

im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...

02 March 2021 2,246 2 View

Anyone found any research papers on solar furnace design calculations (for solar concentration)?

I am thinking about working on solar furnace with heliostats that concentrate sunlight and heat molten salt, but currently no luck with research. Not a lot of papers based on the subject. (check...

01 March 2021 5,023 5 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

How to size battery banks?

I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...

28 February 2021 1,638 3 View

1 nm thick MgO thin-film to be deposited on Si wafer using thermal evaporation. What will be the optimum deposition conditions?

Favourable conditions of base pressure, rate of deposition. Also, by which characterisation technique to be used to verify the thickness of the deposited film.

28 February 2021 3,640 3 View

Dapi fluorescence protocol for colon cell lines ?

28 February 2021 2,534 2 View