26 August 2019 1 4K Report

Hi!!!

I´m going to sonicate a few millions of JVM2 for a trasncription factor ChIP; but since I never did that, I will have to check all conditions (crosslink time, sonication time, sonication buffer composition...) but since this is a lot of work and time I´am asking for someone who maybe did that just to orientate my workflow.

Thanks in advance.

More Oscar Recasens's questions See All
Is it possible to improve the reforming section of the Haber-Bosch process without using air separation units?

A typical reforming section in a large-scale Haber-Bosch process (Figure 1) comprises two reactors. A mixture of methane (CH4) and steam (H2O) is fed into a primary reformer to produce syngas via...

01 August 2024 7,051 5 View

Is there any real advantage in co-electrolyzing CO2 and H2O in liquid phase to produce syngas versus using separated electrolysis of H2O and CO2?

Electrochemistry is a pathway to convert CO2 into valuable products such as CO. However, a potential side product in the cathode is H2. I wonder if it is possible to tune the composition of the...

12 May 2024 9,061 3 View

How to prepare aliquots of freezing medium (for PBMC)?

Hello everyone, I am working on a project where I receive daily samples to freeze at -80 °C. Specifically they are peripheral blood mononuclear cell (PBMC), until now I was using CryoStor® CS10,...

22 April 2024 3,905 6 View

Can pulsed electric fields be used to generate heat?

Pulsed electric field is considered a "non-thermal" method for food processing that involves the application of short high-voltage pulses to create pores in cell membranes. However, since I am not...

13 March 2024 2,624 6 View

¿El Sistema Político salvadoreño se puede calificar de izquierda, derecha o indefinido?

De acuerdo con los cambios o reformas económicas, políticas y sociales

12 March 2024 4,602 0 View

Discuss the impact of public debt on government finances in developing economies, focusing on South Africa?

an essay of 2000 words.

02 March 2024 1,932 4 View

Mutation found in the forward but not in the reverse sequence?

Hi! We are sequencing exon 5-6 from the BEST1 gene, we have multiple patients afected, with the explaining mutation, but in this cohort we found that in our forward sequences we can identify...

07 February 2024 2,284 5 View

Interested in sociohydrology?

Write me an email for infos on a postdoc position. [email protected]

05 February 2024 6,496 1 View

How to calculate the electric field in a capacitor?

The parallel plate capacitor of the figure comprises two metal electrodes separated by a dielectric material. Is the equation shown in the figure appropriate to calculate the electric field in the...

18 November 2023 712 2 View

Primers for STR´s?

Hi everyone and good morning! In our lab we want to make a sanger sequence opf the RPGR gene (ORF1/ NM_001034853.2) but is technically very dificult to make any PCR within that zones (it´s a...

27 September 2023 3,561 4 View

Similar questions and discussions
Can i use the protease inhibitors during cell membrane vesicle preparation ？?

I am currently working on a project that involves extracting cell membranes, for which we disrupt the cells using sonication. During the initial extraction process, we add protease inhibitors to...

30 July 2024 7,077 1 View

Can I use sonicator only to lyse the exosomes and measure their protein contents using BCA assay kit?

Hello, I want to ask regarding exosome protein quantification method. Is it necessary to lyse exosomes before measuring their protein contents using BCA assay kit? Or can I just straight away...

23 July 2024 4,603 4 View

Are there always been barcodes, apapters and primer sequences in the FASTQ files of NGS?

Hello researchers, Sorry for my stupid question. I am learning the QIIME2 workflow for analyzing some 16s amplicon NGS fastq data. I found a very nice paper with data and code public available...

20 July 2024 5,405 2 View

What is the suitable solvent of MIL-100 for chemotherapy?

I synthesised a nanocarrier by conjugation MOF (MIL-100) with folic acid for use in chemotherapy but the samples didn't dissolve completely in aqueous solution or DMSO. Instead, they only...

15 July 2024 2,414 1 View

How to disperse silverparticles in water?

I synthesize silver nanoparticles ，and reserve it in water. Then, when I sonicate it some minutes or longer ,it couldn't be dispersed, most of them aggregate .Otherwise ,when I sonicate several...

09 July 2024 7,335 0 View

What is the reason of appearance of 2 or 3 peaks in zeta potential analysis of sample?

Hello I have prepared metal nanoparticles and did zeta potential. Normally there is a single peak in sample but now there are 3 peaks. I prepared sample for analysis first I prepared 10 mg/mL...

30 June 2024 1,063 4 View

Curcumin encapsulation in Bovine Serum albumin (BSA)?

Hey all what are the ways by which an encapsulated drug inside BSA may escape from its encapsulation. We had synthesised curcumin encapsulated BSA by desolvation method followed by centrifugation...

23 June 2024 8,785 5 View

What is the appropriate filter size?

I have truck tire particles that I am using in my column experiment. I am trying to do size determination using the Malvern Zetasizer. My sample concentration is 0.1 mg/L, i.e., 10 g of sample was...

22 June 2024 8,857 6 View

What does an increase in intensity mean in GIXRD?

When I examined the GIXRD data obtained recently, I observed that the sample treated with O2 plasma on the Cu surface deposited on Si chips showed increased intensity compared to the sample...

19 June 2024 6,900 5 View

How can I optimize the protocol of pirfenidone loading into the exosomes (sonication or electroporation)?

What parameters are important in this process?

17 June 2024 4,463 0 View

Our partners will collect data and use cookies for ad personalization and measurement. Learn how we and our ad partner Google, collect and use data. Agree & close