Hi!
I am looking for any paper published where this device (Back Strength Dynamometer - Takei TKK 5402) would have been used or even validated.
Does anybody know about any publication related?
Thank you very much in advance!
Joel Puente Fernández.
I finally found one! Thank you very much anyway! :-)
Just in case it was of your interest:
"Validity of an isometric mid-thigh pull dynamometer in male youth athletes" (Till et al., 2017).
Best regards!
Joel.
There are a handful of papers in Google Scholar where the gadget is mentioned.
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...
07 August 2024 9,563 0 View
I am Looking for a Science Journal with good impact factor and low publication cost to publish a review paper. Your suggestions would be appreciated.
06 August 2024 6,796 3 View
I received an e-mail invitation to join the editorial board of Clinical Cardiology Updates. While I have published a few articles related to cardiovascular disease, there are lots of colleagues...
06 August 2024 8,981 8 View
Hello all, I wanted to know, can I use galaxy (USA, Europe or Australia) platform for analyzing the shotgun data, and can it be used for publication purpose as well? Thanks :)
06 August 2024 6,610 4 View
I attempted to make a privately uploaded text public but a window appeared that said an error occurred. There was no explanation provided as to why there was an error or what might be done to...
05 August 2024 8,025 7 View
If the placenta is delivered in squatting position within 3 minutes of the birth of the baby, postpartum hemorrhage is completely eliminated. It works every time. It is quite likely that if a...
05 August 2024 8,895 0 View
How do you tie-break and rank these two in their strength?
03 August 2024 4,471 1 View
Machine learning (ML) has shown great potential in predicting the compressive strength of concrete, an important property for structural engineering. However, its practical application comes with...
03 August 2024 2,546 2 View
need to open an account to upload my published papers
01 August 2024 9,255 1 View