I have a mouse primary antibody and I would like to use the same in the rat tissue for IHC purpose. Does that really work?
Thank you
Harsha
Hy,
of course you can use primary mouse antibodiesand detect them with secondary anti-mouse in rat tissue.
You can do also the inverse way and use rat primary antibodies in mice.
Good luck
Stefan
Hi Stefan,
Thank you for your answer
Unfortunately, secondary antibodies against murine primary antibodies cross-react with rat antibodies. This results in a nonspecific IHC reaction
Hi Igor Ivanovich Babichenko,
Thanks for your valid point. I should consider that point as well.
Regards,
I am working on FTC for handling sensor faults in the system. I have read about observer-based FTC schemes which use error threshold-based logic between the states and estimated states. If a...
10 January 2021 5,771 2 View
I want to know whether a luenberger observer or a modified form of it be effective for estimating the states of a system of the following forms: 1. x_dot = f(x,u,d); y = x 2. x_dot = f(x,u); y =...
20 December 2020 1,392 4 View
I am trying to simulate a planar, high ohmic DC gas-discharge system. The model consists of a coupled set of equations, drift-diffusion for ions and electrons, and Poisson's equation in the gas...
07 December 2020 8,521 2 View
I have a time series of two rainfall products. For error decomposition analysis, I have to calculate HB, MB and FB. Is there any software for calculating these variables.
27 November 2020 980 2 View
I want to target particular protein/peptide/enzyme by cell culture methods. I would also like to know screening methods for cell cultures to analyse and diagnose the drug effect on particular...
24 November 2020 7,255 5 View
Hello, I am trying to understand the fate of pesticides based on the fugacity multimedia approach. Is there software for such modelling? I know SWAT can be used for watershed-level pesticide...
15 October 2020 1,424 3 View
I am working on voltage control of a Standalone DC Microgrid consisting of Single PV source, a battery and loads. The PV is interfaced through Buck converter to the DC bus, the battery is...
01 October 2020 7,071 2 View
I am cloning a whole cDNA of a particular gene and I have designed forward primer at start of 1st exon. The region downstream of forward primer is extremely high GC rich (around 85-89%). Because...
17 September 2020 6,571 11 View
I have created a beam and i dont know, what is the maximum load it can take, Is there any way to increase the load continuously without giving a fixed value, so that at some load the beam will...
02 September 2020 6,246 9 View
16 August 2020 730 8 View
Instead of checking only the mRNA level, I want to check the active protein level of MMP-1 in Liver tissue from mice. How can I do that?
03 March 2021 1,763 2 View
i have problem in preparation of liver tissue with bad cell organelles and how i can adjust osmolarity
03 March 2021 8,890 1 View
Interested to stain mice brain tissue with WGA 488 conjugate, appreciate if anyone willing to offer me some guidance or suggestions! Thank you!
28 February 2021 3,951 2 View
I have two groups of brain samples, control and treated for example. It was total RNA nova seq sequencing. I tried all the available pipeline like: star+rsem+deseq2, Hista+stringtie+cuffdiff,...
27 February 2021 356 6 View
Hi everybody, I have been running a multiplex IHC which allow me to stain the same tissue with different markers (Primary Ab + Secondary conjugated Ab) (AF487, AF555, AF647). Since I would like to...
27 February 2021 5,028 2 View
Hello. I am looking to extract genomic DNA from mouse brain and lungs and I need a kit that is not spin-column based because I need to scale up the solution amounts for 400mg tissue (most cap at...
25 February 2021 155 2 View
Hi Everyone, I am designing a pilot study using rodents to assess the effects of simulated space environments (radiation + altered gravity) on microbiome and immune system. I have limited...
24 February 2021 1,825 3 View
I have an old slide microarray scanner (VIDAR Revolution 4200) and would like to give it a "second life", as IHC scanner array (fluorescence dyes), FISH over tissue or similar. Has anyone tried...
24 February 2021 9,210 1 View
I will be performing RNA isolation with frozen lung biopsy samples and am in the market for a tissue homogenizer. I am wanting a homogenizer that will fit in a 1.5ml tube. I was looking at the...
24 February 2021 3,623 3 View
Hi Everyone, I am a bigginer in western blotting and I am trying to use it for validation of my proteomics data. I have: two regulated proteins with molecular mass of 40 and 73 kDa one control...
23 February 2021 6,671 4 View