We obtained FT-Raman results for our sample and the spectrum shows broad peaks.
There are various reasons why nanoparticles might give broad peaks, but what do you mean by 'broad'? 30, 100, 1000 cm-1?
what material? and, as above, what spectrum?
zinc nanoparticles
I have obtained characterisation results for my electrodeposited CuNPs and I'm looking for the suitable application(s). I'm ready to accept the collaborator for the same if any one is interested...
10 November 2018 3,900 4 View
Our current research paper describes the synthesis of Copper-Zinc bimetallic nanoparticles by electrodeposition technique with characterisations on TEM, SEM, DRS, XRD, XPS etc.,
04 May 2018 9,684 1 View
we have synthesized a bimetallic nano alloy which clearly gives TEM micrographs with clear lattice fringes and would like to identify the hkl
10 November 2017 2,622 0 View
I am indented to take zeta potential for my sample for that the refractive index is required.
01 February 2016 7,843 1 View
Read 1 answer by scientists to the question asked by Singaravelan Ramakrishnan on Nov 9, 2015
10 November 2015 9,723 1 View
I need to know whether the modified Scherrer equation is useful in calculating the accurate size of the nanoparticle comparing Williamson-Hall equation.
08 September 2015 7,688 6 View
I'm looking for the research collaborator in the field of nanoscience for my paper publication. My research is based on the synthesis and characterisation of metallic and bimetallic nanostructures...
01 January 1970 9,156 4 View
Do these peaks in the curve indicate primer dimer or non-specific products?
01 August 2024 7,466 0 View
Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...
30 July 2024 435 3 View
I'm using a InVia Renishaw Raman microscope system (785nm wavelength, 600l/mm grating density) to acquire Raman images on human brain samples, at 50um resolution. The samples are placed on MgF2...
30 July 2024 8,771 3 View
Dear all, I have noticed, as the ZnO content increases, the Raman intensity at 100cm-1 also increases. However, there is a peak nearby at 130 cm-1, which I could not find in any paper related to...
28 July 2024 5,410 1 View
I do not know much about FTIR! The material Benzethonium Chloride USP was compared to a reference standard in regards to FTIR, as per the USP testing: Identification B. Infrared absorption (FTIR),...
16 July 2024 6,918 7 View
During the release test of Amphotericin B using 1% Tween 80, i observed three peaks even in the standard. The first peak consistently yielded results around 500%, while the other peaks showed...
08 July 2024 1,330 0 View
I synthesized some paramagnetic cobalt and nickel complexes (expected to be Co(II) and Ni(II)) using a bidentate ligand - N of pyridine ring (aromatic) and O of P=O (aliphatic), and I obtained...
03 July 2024 3,410 4 View
I'm trying to fitting Cu Auger peak into various state (Cu0, Cu+, CuI etc..) In Cu0, one of the peak's FWHM is 0.84 but when I try to enter smaller value than 0.89, "input error" is occured. How...
02 July 2024 4,932 3 View
I am in the process of roughening a silver electrode for SERS measurements using the latest version of CH Instruments. Most procedures in the literature mention sweeping the potential from -0.3 V...
30 June 2024 4,639 3 View
Hello I have prepared metal nanoparticles and did zeta potential. Normally there is a single peak in sample but now there are 3 peaks. I prepared sample for analysis first I prepared 10 mg/mL...
30 June 2024 1,063 4 View