Did anybody have any experience in friction stir welding of dissimilar alloys AA 354 and Mg Az91 ?

What is the reason for current dropping in OER , LSV curve?

I tried four trials of the same Copper Phosphides sample in Alkaline medium ( 0.5M KOH) with Hg/HgO reference electrode and Pt as counter electrode. I used 0.001 V/s scan rate for first three...

10 August 2024 3,629 1 View

Is there anyone with experience in TEM analysis who can assist with a manuscript for an upcoming journal?

Hello dear colleagues, We have prepared a manuscript on NiTi-based alloys and are seeking a second opinion on our current TEM results. If you are a Ph.D. holder with experience in TEM and have...

07 August 2024 9,563 0 View

How select composition for ods-high entropy alloys?

31 July 2024 2,795 1 View

How should operational parameters be selected when developing a pore-free laser welding technology?

There are three operating parameters - the laser power, the diameter of the focus spot and the scanning speed. It is necessary to obtain a seam of a given depth without pores. What parameter...

27 July 2024 7,168 2 View

I am trying to obtain microstructure for Mg-Zn-Sn alloy?

Any suggestions with respect to etchant composition and holding time?

27 July 2024 6,925 2 View

Will the catalytic effect of retained austenite happens in steels including RA?

The catalytic effect of retained austenite refers to the phenomenon wherein quenching steels with a small amount of retained austenite, when subjected to tempering at a specific temperature...

27 July 2024 8,508 0 View

What is the physical meaning of the magnetic scalar potential?

In cases where the rotational of the magnetic field H is zero, we can define this field as the gradient of a scalar function defined as the magnetic scalar potential (similar to the electric...

21 July 2024 9,633 4 View

What is the angular difference between two sets of Euler Angles?

Let's say I rotate a hexagonal crystal using Euler angles (φ1, φ2, φ3); and rotate another similar crystal using Euler angles (ψ1, ψ2, ψ3). What would be the angular difference between the final...

17 July 2024 5,582 1 View

Masonry Interaction Module ABAQUS?

I am simulating interlocking / dry stacked masonry in Abaqus. I am using a friction coefficient of 0.6 for my model as it is stated in the previous research as well as in the base paper. The...

16 July 2024 5,047 0 View

What is wrong about this model of Universe?

A universe model compatible with VSLT The research of Halton Arp and Eric Lerner supports a stationary universe, and the intrinsic nature of redshift, i.e. not linked to its presumed expansion...

14 July 2024 4,092 5 View

M. E. Kazasidis

You have to give more details, as the thickness of the alloys you want to join.

Seyed Vahid Safi

the 5 mm thickness sets for the both alloys

Joseph Ahn

It might also be useful to say which FSW tool you're using as the tool design is critical in FSW.

the tools profiles geometry that we used are threaded cylindrical and threaded conical