I am trying to model a single spark discharge for electric discharge machining process in abaqus using DFLUX subroutine. The heat flux for my model is Gaussian distributed for an axisymmetric model. The problem is I am not getting any temperature profile after running the subroutine. Can anyone please help if there is any error in my subroutine or any problem in my model. I am attaching the DFLUX subroutine. Thank you.
Dear Team
we are very Interested too.
Please contact us
Dr.-Eng.Ph.D. Abd-Ellah Abo-Hegab Founder & Executive & Head
With Best Regards - Im Voraus vielen Dank - Cordialement -Cordiali Saluti -Un saludo-
Eprdv-Engineering Co. & Ltd Head Office: Rosenheimer Str. 126 B, D-81669 Munich, Germany Mobile +4917654696651, Whatsapp, Line, IMO. Viber Skype ID: dr.eng.hegab, Whatsapp, Imo, Viber, Line 📷 Website: www.eprdv-engineering.com email: [email protected] DISCLAIMER: This message is intended only for the use of the person(s) ("Intended Recipient") to whom it is addressed. It may contain information which is privileged and confidential. Accordingly any dissemination, distribution, copying or other use of this message or any of its content by any person other than the Intended Recipient may constitute a breach of civil or criminal law and is strictly prohibited. If you are not the Intended Recipient, please contact the sender as soon as possible.
Dear Samghamitra,
You did not mention step number and heat flux type (body or surface type) in your subroutine. Abaqus can not understand that for which step you are giving load and which type of load, you have to mention it.
Dear Abhishek Kumar
Can you please let me know what changes exactly I have to make in the dflux subroutine. Thank you for your valuable suggestions.
Dear Samghamitra,
You have to add JLTYP (= 0 or 1 depends on load type) in your subroutine and also JSTEP (=1,2,3...whatever step number is). You can take help from ABAQUS documentation.
- Badges
- Science topic