What are the most effective parameters to reduce radiated emissions on capacitive touch sensors?

On the pcb board i have added the series resistor in sensor line in different values. But with increasing the value the radiated emission is still high and there are a lot of peaks in some...

09 October 2018 2,835 0 View

Hi, I am adding the series resistor value to the capasitive sensor , but the Radiated emission is increasing at low frequencies. What is the reason?

By adding the resistor value the LPF must increase and high frequencies will eliminate. So we must have lower radiated emission

09 October 2018 357 0 View

Can anybody introduce me a good paper and useful book in the field of Rf/Microwave cancer biosensor?

11 December 2016 5,498 0 View

I need to know the differences between Electromagnetic Simulation Softwares and the comparison between them?

for example the comparison between MEEP and EM EXPLORER softwares.

06 July 2016 1,595 0 View

Which other open source (or, in any case, "free") implementations of FDTD and RCWA are available, and to compare their capabiities?

05 June 2016 6,824 6 View

No title

Si Nanowire

05 June 2016 766 0 View

No title

molecular transistor

05 June 2016 9,749 0 View

Can anybody helps me and propose some good thesis in field of nanotechnologies for ICTs?

In field of Biomedical or other fields that related to nanotechnology

05 June 2016 5,377 0 View

In FinFET technology do shorted gate(SG mode) and independent gate (IG mode0 still using and i need some datas about these modes?

FinFET technology

03 April 2016 1,222 0 View

What is Flip-chip technique?

interconnect

01 February 2016 4,488 1 View

Physics: Why do we describe light by referring to its wavelength, but microwaves and radar pulses by referring to their frequency?

In physics, the description of the properties of light generally refers to its wavelength (nm), while in the range of microwaves and radio waves we refer to the frequency of a signal (e.g. kHz or...

03 March 2021 1,682 3 View

How to compare two groups with only two measurements?

Hiiiii everyone! I have an enquiry on statistical analysis. I was looking for many forum and it's still cannot solve my problem. I want to compare means of two groups of data but only with two...

03 March 2021 8,796 3 View

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10?

What's the best way to measure growth rates in House sparrow chicks from day 2 to day 10? Since, the growth curve from day 2 to 10 won't be like the "Logistic curve" it might not follow logistic...

03 March 2021 1,401 3 View

How to increase a model accuracy ?

dear community, my model is based feature extraction from non stationary signals using discrete Wavelet Transform and then using statistical features then machine learning classifiers in order to...

03 March 2021 6,994 5 View

1. What is the impact of having different scales in a survey? and how can we solve this problem before and after data collection (Literature)?

1. What is the impact of having different scales in a survey? and how can we solve this problem before and after data collection (Literature-based reflection)? Thank you for your time and for...

03 March 2021 2,870 3 View

What degree of missing data in a particular case/participant results in Expectation-Maximisation no longer working?

I'm dealing with a mediation model and am using the PROCESS module in SPSS. Due to SPSS and PROCESS being limited in the imputation methods - being unable to handle multiple imputation - the other...

02 March 2021 4,362 1 View

Why are the velocities so high in my Boussinesq approximation Fluent simulation?

Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...

02 March 2021 4,910 3 View

Why almost every element would be metallized in sufficiently high pressure and low temperature?

(This statement is from wikipedia, BTW). What is so special about metallic bond that is limiting high-P low-T state of a matter (as long as individual atoms exist, not white dwarf of neutron star...

02 March 2021 3,309 2 View

What element is driving the different slop in the low frequency tail?

My study consists simple corrosion inhibitors in salty brine. Right now I just fit my circuit with randles with CPE. Just wondering how the slop can given more info of the experiment. Or any...

01 March 2021 6,474 3 View

Can NFL theorem be valid in infinite search space in ML?

NFL theorem is valid for algorithms training in fixed training set. However, the general characteristic of algorithms in expanded or open dataset has not been proved yet. Could you show your...

01 March 2021 1,189 3 View