What are the most effective parameters to reduce radiated emissions on capacitive touch sensors?

On the pcb board i have added the series resistor in sensor line in different values. But with increasing the value the radiated emission is still high and there are a lot of peaks in some...

09 October 2018 2,835 0 View

Can anybody introduce me a good paper and useful book in the field of Rf/Microwave cancer biosensor?

11 December 2016 5,498 0 View

I need to know the differences between Electromagnetic Simulation Softwares and the comparison between them?

for example the comparison between MEEP and EM EXPLORER softwares.

06 July 2016 1,595 0 View

Which other open source (or, in any case, "free") implementations of FDTD and RCWA are available, and to compare their capabiities?

05 June 2016 6,824 6 View

Describe how a possible circuit based on molecular transistor could be simulated starting from data at the physical level?

molecular transistor

05 June 2016 5,509 1 View

No title

Si Nanowire

05 June 2016 766 0 View

No title

molecular transistor

05 June 2016 9,749 0 View

Can anybody helps me and propose some good thesis in field of nanotechnologies for ICTs?

In field of Biomedical or other fields that related to nanotechnology

05 June 2016 5,377 0 View

In FinFET technology do shorted gate(SG mode) and independent gate (IG mode0 still using and i need some datas about these modes?

FinFET technology

03 April 2016 1,222 0 View

What is Flip-chip technique?

interconnect

01 February 2016 4,488 1 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before?

Question to you and THEM, the New Journal, "Integrative Psychological and Behavioral Science" -- do you not know, and have you not seen, this done before? There appears to be a core problem for...

02 March 2021 3,024 2 View

Does any one can help me choose a reasonable basis set for intermediate metal ions interactions with guanine (i.e Fe2+, Mn2+, Cu2+ and exc.)?

Hello every body Does any one has any idea to help me choose a reasonable basis set for intermediate metal ions (i.e Fe2+, Mn2+, Cu2+ and exc.) interactions with guanine or other DNA organic...

01 March 2021 6,187 2 View

What could be some reasons why unstimulated monocytes are getting activated?

Im doing PBMC isolation -> CD14+ enrichment using magnetic beads -> stimulation setup. My negative control is just cells in cRPMI but they seem to get activated over and over again.

28 February 2021 7,883 3 View

Why does intensity drops as concentration increases?

Is there any reason for decrease in fluorescence emission intensity of HSA,BSA when increase the concentration ?

28 February 2021 3,653 4 View

POlymer+DMSO solution and moisture??

What could be the reason of moisture at the sides of Vial when I am preparing my polmyer+DMSO solution for membrane fabrication? What etiquettes I am possibly missing here?

28 February 2021 6,516 5 View

Should we reduce the standard unit of length to 0.31951540592 meter ?

The reasoning behind this question is to align the ratios of the proton potential in energy per charge to the speed of light in distance per time. As these two dimensions appear to be related,...

27 February 2021 947 7 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

What could be reason for getting such type of graph for complex impedance in case of polymer blend films?

Its effect appears in real part of ac conductivity also. Can anyone suggest any reason behind it?

26 February 2021 3,487 3 View

What might be the reason for obtaining two bands in plant genomic DNA extraction?

I got a thin band and a thick band i guess it would be the genomic DNA and the 260/280 ratio is 3.

21 February 2021 6,523 6 View