Data signal through a twisted pair cable by using different color codes will work ?

More Arunkumar Lakshmanan's questions See All

What happens when we culture cancer epithelial cells in TCPS?

What happens when we culture cancer epithelial cells in TCPS?. Is the cell present as epithelial or differentiate into mesenchymal cells?.

24 August 2020 9,116 2 View

How to measure the heat transfer in hollow block?

what instrument is used for measuring heat transfer

06 January 2019 3,087 3 View

How to find the effect of signalling molecule on metabolic pathway?

I am started working on " BMP over breast cancer". I am interested to know, is there any system biology tool available to predict the possibility of BMP interaction over the metabolic pathways (...

28 January 2018 5,271 3 View

Anyone have experience in performing native immunoblot for cell supernatant IP samples?

Can anyone suggest a protocol to verify the oligomerization of secreted protein using immunoprecipitation and native immunoblot.

22 October 2017 2,177 2 View

Can anyone suggest a good method/paper to mass produce TEV protease ?

I am planning to produce TEV protease in my lab because I will need a lot of the protein in order to cleave the fusion tag off the recombinant proteins which I will be producing in E. coli. Do...

03 November 2016 6,281 3 View

Is the numerical value of positron diffusion constant different from surface to bulk of the solids?

If I consider positron diffusion length L+ is constant through the solid. But by VEPFIT I am getting two layer (surface and bulk) of the solid

02 February 2016 1,270 1 View

Is there a colorimetric assay to quantify terpenoids from plant extract? Which is the best way to quantify terpenoids apart from GC-MS analysis?

Apart from GC-MS analysis which method would be best to quantify terpenoids from plant extract?

27 March 2015 7,764 8 View

Is it possible to separate nano particles from polymer?

I synthesized a polymer and when i try to use it polymer for drug delivery the size is more than 200nm. So i did mechanical distribution and separated particles less than 200nm and applied for...

11 February 2015 7,114 6 View

Is there any relationship between crystality & photoluminescence of the material?

My friend told me crystal materials only have luminescence properties. Is it right?

14 January 2015 6,612 4 View

How can one obtain a better yield from Palm oil fractionation? Is 85% achievable on a PO IV of 53?

What would the cycle time be?

02 December 2014 8,369 3 View

What is the most Operating System (OS) which can be INSTALL on Tiny hard devices like Raspberry Pi (RPi) hardware ?

I'm targeting to deploy a mesh network and manually configure MANET routing protocols. I'm preparing scenarios, architectures, and hard devices needed to do that. Are there some step-by-step...

03 March 2021 1,931 5 View

Waters 2707 HPLC autosampler problem?

I am using a 2707 waters HPLC device. When I try to inject a sample, it says missing plate or rack. I changed the needle and calibrated its position but I still get the same problem. I even get...

02 March 2021 1,408 1 View

How can I integrate a routing protocol in a tiny device (e.g. Raspberry Pi)?

Hi Community, I'm facing the issue of integration/compiling a new routing protocol in a WSN simulator. The final goal is to successfully add, configure this routing protocol in hardware devices...

01 March 2021 9,332 6 View

Gas sensor response and recovery time independant of flow rate and chamber volume?

I am trying to obtain the response and recovery times for my gas sensor device. It appears the the response/recovery times are primarily dependant on the flow rate of the gas I inject into the...

26 February 2021 1,511 3 View

How to calculate battery consumption for IoT device?

Hi, everyone I'm working on a privacy-preserving algorithm that will apply to IoT devices. So, I need to measure the power consumption by implementing this algorithm. Any suggestion, advice,...

25 February 2021 8,749 6 View

How to troubleshoot Electrochromic Films and Electrochromic Devices?

I am trying to characterize an electrochromic system. The system uses ITO electrodes on glass, WO3 as the electrochromic film, and NiO as the ion storage layer. When I deposit NiO and WO3 and...

23 February 2021 9,592 2 View

Alternative to mediation analysis?

I am currently working on my dissertation and want to explore the role of competence as a mediator between the effect of colour of clothes on voting intention (focus on Western countries)....

21 February 2021 8,609 1 View

Color of spiro-ometad film?

What does the color of a spiro-ometad film indicate? I got purple, green, red, even black color of the spiro film. Is there anything we can get from the preliminary color analysis(e.g. oxidation...

21 February 2021 1,831 4 View

Which vial septa the right one to be used for HPLC?

This is the unanswered question stored very long in my mind and till now I could not find a right answer. Google search educated me that the red surface is the PTFE material compatible to wider...

21 February 2021 546 3 View

Are ZnS nanoparticles moisture sensitive?

Hello Everyone, I tried to form ZnS nanoparticles using the hot injection method and was able to form the same (confirmed by XRD). When I centrifuged, after the reaction I got a kind of white...

17 February 2021 1,709 3 View

Michael Bach

Are you serious?

The colour is totally irrelevant for a twisted pair to use. Make sure they're correctly connec at each end, of course.

Arunkumar Lakshmanan

thanks a lot Mr. Michael for the response.

Even though if i use different colors, Still the EMI cancellation will work out right?

Peter Derr

You must maintain the use of twisted pairs for noise reduction. A simple review of magnetics and the right hand rule should add clarity