I am using DasyLab with NI-USB 6521. but i am not activate the NI-USB 6521 deice to use with DasyLab and to use the icon Analog input MCC-DAQ.
I need help to read the sensor date output to USB device
need a circuit diagram to read in dasy lab as a help which i wil later on program in Dasy lab.
a sensor has an output of voltage 0-10V.
Hi, r u able to see DAQ system in DasyLab, if yes the click on it it will ask signal type, select voltage the it will ask channel no. , foe what application u want to acquire the signal?
I have NI:USB 6251 and want to check and try the syystem. for that i have 4-20mA current supply. i will put 500ohm resistor and get 10V voltage suply. I will regulate the voltage supply through changing current.
for that i have one + (positive9 cable goes with A1 and one Nagative goes with A1 (ground)
My question is the wiring is ok?
can i set the parameters in Dasy lab without the input in NI USB6251?
Do you have any muster or example through which i can make the circuit in Dasy lab (Just to check the device and read the signal in dasy lab)
Whare can i check if i can see the DAQ in dasy lab
I want to use the dasy lab to measure the vibration and RPM
@Nilaj Deshmurkh can i have you e mail address need a help in Data Acquisition through dasy lab
- Badges
- Science topic