porosity
coating
film
EIS
impedance
Here are some papers, as desired by you.
a) https://link.springer.com/content/pdf/10.1007/BF01008882.pdf
b) pubs.acs.org/doi/full/10.1021/jp512564f?src=recsys
c) jes.ecsdl.org/content/159/7/A1034.figures-only
d) www3.ntu.edu.sg/ThinFilms/mae-thinfilms/Thinfilms/pdfpapers/DRM-11-160.pdf
e) https://www.ameteksi.com/-/.../technical%20report%2024%20gabrielli%20application
f) www.fhi-berlin.mpg.de/.../cornelia_breitkopf__impedance_spectroscopy__121207.p...
corrosion inhibition Surfactant Dispersing nanoparticles mild steel corrosion acidic media
02 March 2018 3,556 5 View
calcium complex plant extracts
31 December 2017 4,069 3 View
anodic tafel slopes
04 May 2017 3,303 1 View
nanoparticles dispersion ultrasonic corrosion inhibition
03 April 2017 3,424 5 View
seebeck coefficient fermi energy nanoparticles addition
31 December 2016 8,736 4 View
mild steel in 1 M H3PO4 shift in solution resistance reaction of Fe with H3PO4 EIS at different tempratures
31 December 2016 2,438 5 View
neutral media nanoparticles supercapacitors
31 December 2016 7,584 5 View
seebeck coefficient nanoparticles carrier concentration
11 December 2016 2,153 0 View
thermopower thermo properties nanoparticles
11 December 2016 8,157 1 View
nanoparticles co-precipitation method EDTA PVA capping agent
10 November 2016 1,319 1 View
How can I determine a good adhesion strength range for coatings on polymer surfaces, such as DLC on polymer substrates? Is there a specific threshold for adhesion strength (from T-peel tests)...
10 August 2024 942 3 View
I did PR spin coating on trench structure. I used AZ P4620 PR and the thickness or PR is around 11um. The substrate is Si. And my trench structure depth is 141um(negative way). Even though I...
08 August 2024 2,298 0 View
I have been getting a low plasma and no coating while doing rf sputtering of copper doped ZnS using a power of 140 watts and at pressure of 6.5x10-3 Mb.
07 August 2024 4,526 4 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
Following curve related to Co0.6Mn0.4Fe2O4 Magnetic nanoparticles with extra phase a-Fe2O3. I will appreciate to help me to interpretation this spectroscopy, especially the blue line.
31 July 2024 9,140 2 View
I am trying to coat my micelles and PLGA based nanoparticles with cell membrane using an Avanti mini extruder according to literature . I use 200nm membrane but my particles end up to be 400nm And...
30 July 2024 3,294 3 View
Hello everyone, I am new to this characterization but watching videos on youtube I have already plotted a Nyquist plot (Z' and -Z'') and already fitted models on my material using Zsim. But now I...
29 July 2024 1,376 0 View
While I am doing HER, I noticed that nyquist plots of Electrochemical Impedance Spectroscopy (EIS) is not complete. Will it affect for the Linear Sweep Voltametry (LSV) data? However, I can found...
26 July 2024 7,542 4 View
In the context of Electron Spin Resonance (ESR) spectroscopy, under what conditions is an absorption spectrum considered to be a single absorption spectrum?
25 July 2024 2,325 1 View