I am trying to do with the combination of two metal as one electrode by doping it. Is it feasible, can we dope it or will the results be efficient.
Dear Sri Kantha,
I might not be fully understanding your intention/question.
Normally ECC might use a bimetallic combination with a Bipolar electrode arrangement
In example: Fe / Al / Fe / Al / Fe
What bimetallic combination are intending to use for ECC?
Thank you for your suggestions. I am intended to do with the same combinations Fe/Al.
Hello, If I understood your question correctly, i believe it'd depend on the successful doping of Fe in Al or vice versa.
In response surface methodology, while calculating central composite design Minitab software shows 20 runs for 3 factors where as in Stastica software it shows only 16/17 runs. Which software is...
01 February 2018 1,924 1 View
While calculating filterablity of sludge, I need y=mx+c equation to calculate alpha and Rm . I found that in some of the literature they have mentioned some units for slope and intercept. Does...
01 February 2018 3,753 3 View
As i tried to make a working matrix for RSM in minitab software. I found 27 matrix, but as i went through so many journals they are considering only 15 to 20 run in CCD. I found that there are...
10 November 2017 9,120 0 View
On what basis the reactors are designed and please let me know how to design a laboratory scale reactor
02 March 2016 8,079 1 View
Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...
10 August 2024 6,493 1 View
I'm currently working on calculating the collision cross section (CCS) for various ions, and I'm facing challenges when dealing with sodiated and multiply charged ions. Most of the resources I’ve...
08 August 2024 8,329 0 View
A fungal strain was treated with nanoparticles. We want to do an environmental SEM analysis. So could anyone share your views on preparing the sample? Thank you.
07 August 2024 5,307 1 View
For example, I perform passivation process before electropolymerization of Py for adhesion to titanium surface. Is a similar or different procedure required for ITO? If necessary, I would be glad...
06 August 2024 3,176 0 View
After immunohistochemistry of previously fixed in PFA and EtOH and then frozen 20 μm sections of zebrafish brain, DAPI staining is very weak (right) compared to the same sections stained without...
05 August 2024 9,637 2 View
Hello everyone, I'm encountering an issue with my electrochemical impedance spectroscopy (EIS) measurements and would appreciate some insights. Experimental Setup: Electrodes: Gold interdigitated...
05 August 2024 3,783 2 View
I have tried several times to isolate lymphocytes from mouse spleen, but all attempts have been unsuccessful. I tried most available protocols. I used different dissociation media (HBSS with Ca...
04 August 2024 9,913 7 View
Reference dose and Maximum acceptable concentrations HMs
03 August 2024 8,230 4 View
AI-driven technologies offer previously unheard-of capabilities to process enormous volumes of data, extract insightful knowledge and improve predictive models, according to the UN’s World...
31 July 2024 9,733 3 View
I am currently working on a project involving liposomes and need to determine the maximum volume of siRNA that can be added to a 2.5 mL liposome solution with a total lipid concentration of 10...
30 July 2024 6,420 1 View