Conversion of 1 Liter to Kg of Septic Tank Sludge?

16 March 2023 0 8K Report

Hello Everyone,

I have a question about how I can convert 1 Liter of septic sludge to kg. Also, what is the total solids (%) of septic sludge?

Thank you very much

Badges
Science topic

More Adam Jonson's questions See All

Phengaris rebeli on Picea abies?

Today I took this video in Southern Bavaria, Germany. Video: https://www.youtube.com/watch?v=cCy1eLM6aE0 A female Maculinea rebeli was continuously tapping the leaves of Picea abies with its...

15 July 2024 8,099 4 View

Please tell me the scientific guidelines (books) on Trombidiformes ticks?

books and scientific papers on the morphology, taxonomy and so on of ticks of the suborder Trombidiformes

17 June 2024 948 2 View

Do plants produce hormones that have the same influence properties of animal hormones?

I know that all animals and insects produces hormones. Do plants produce hormones that can have an equivalent effect on an animal like animal hormones?

13 June 2024 3,860 1 View

Micelle vs liposome?

I hope we will not need to reinvent the wheel. Quick (maybe not very smart) question: How do you distinguish between these tw particles? Any proposed technique will definitely provide the answer....

21 May 2024 9,073 5 View

Why there is a increase in participants in road running events?

There is a huge demand for road running events such as marathons in past couple of years. why?

01 May 2024 3,612 0 View

Which of the following proliferation-tracing dyes perform the best?

I'm designing a cytotoxicity assay to measure the effect of treatment on proliferation. My specific objective is to compare the number of cells with 1 and 2 divisions in treated cultures to...

24 April 2024 2,566 0 View

Cointegration in case of the mixture of I(0) and I(1) stationary variables?

Hi! I want to use the ADL model for my data analysis. However, after performing a stationary test, dependent and 6/8 independent variables are stationary only in differences. The other two are...

23 April 2024 9,017 3 View

"Abaqus/standard analysis exited with an error". Is there a solution?

Hello, I am currently trying to run a simulation for my research using abaqus. I have installed abaqus 2022 version and also followed the required steps to link abaqus with intel fortran. I have...

15 April 2024 3,123 1 View

What is the procedure for implementing the DDMRP methodology on SAP S/4HANA and how to do it?

i'm an intern and this is what i'm suposed to do

15 April 2024 6,048 0 View

Dear scholars, could you please share with me free resources (e.g., Online courses and text books) about mulitilevel Linear Modeling?

Any kind of resources.

11 April 2024 9,293 0 View

• What the possible Persistent Organic Pollutants and Heavy metals present in fluorspar, sediments, and water bodies around its mining area?

Approximate concentrations are require in compared with the WHO permissible limts

11 August 2024 2,723 1 View

Basis set and input instruction to calculate HOMO and LUMO using Orca for Imidazolium based organic salts?

Hey there, As a synthetic chemist delving into theoretical calculations for my imidazolium-based organic molecules, I would greatly appreciate any guidance on the appropriate input instructions...

09 August 2024 5,444 7 View

Separation of organic acids-HPLC?

Hello What should be done to separate and identify organic acids in HPC when their RetTime is the same?Like oxalic acid with Propanoic Acid.or acids that have a very close RetTime.

07 August 2024 8,782 3 View

In WECS : Gain values for conversion of PMSM rotor speed(rad/s) to p.u. input to wind turbine and Torque(pu) of WT to input of PMSM-Torque (Nm) ?

I am working on developing a MATLAB Simulink model of Wind turbine with PMSG followed by MPPT Boost converter. I have gone through so many literature and videos but I am not finding clear solution...

03 August 2024 888 1 View

How to convert g/kg Humic acid dose to kg/ha?

I used humic acid at 0.044 g/kg soil in my pot experiment. But finally, I have to recommend kg/ha. Each pot's soil weight was 11 kg. What is the solution?

02 August 2024 7,186 6 View

How to improve peaks separation in HPLC?

Hi everyone, I'd like to better separate two close peaks coming from a bioconversion sample, I'm currently using a C18 KromaPhase 4,6mm Ø.I. SCHARLAU, particle size (µm): 10, pore size (Å): 100,...

30 July 2024 435 3 View

How can one determine the conversion factor for a radiolabeled substrate to a radiolabeled product using slopes from linear regression equation?

I am preparing a radiolabeled product using a radiolabeled substrate. I have the cpm values for different dilutions of both my known substrate and unknown product ? How can one determine the...

27 July 2024 3,604 1 View

How to dispose off lipids waste?

I am looking for a lipid waste disposal method, keeping in mind the environmental, health and safety aspect of lipid waste. Could someone please provide guidelines or the lowest acceptable...

25 July 2024 637 5 View

How to separate the stereoisomers compond in reaction mixture?

how to separate the organic reaction stereo isomers compounds are separate from the reaction mixture any simple methods are available

23 July 2024 8,025 4 View

What additional processing or treatment options are available to enhance biogas plant digestate quality or value?

One has to understand about the enhancement procedures and treatment systems I can list around 12 procedures which are tried and tested and are proven so let us see how many in total the experts...

20 July 2024 3,392 2 View