...
By considering two single-mode Gaussian states at the input of a beam splitter, it is seen that the entanglement of the output two-mode Gaussian state depends on the difference between the degrees...
22 January 2021 3,490 3 View
I can't find any manual or procedure on how to conduct the MMDE process. It looks like most of the literature has copy-pasted the stuff without any method of how to do to it. Any practical book,...
07 January 2021 1,804 2 View
Actually, I want to present the in table form (dcal , dexp, 2 thita, hkl) but don't know how to find these values from data.
28 December 2020 6,769 4 View
As Cronbach's Alpha is usually used for test the reliability of measurements given by questionnaires, however, I wonder that whether I use this test for features extracted from behavioral data. I...
26 December 2020 9,602 2 View
if the percentage of doping Au into rGO is too small 1~10%, is it not enough to prevent restacking of r-GO in xrd results, rGO peak appeared at 22.2 and also the peaks of gold nanoparticles so...
21 December 2020 6,091 3 View
is the concentration of gold salt that were added will affect on the peaks appeared. i added a very little amount of gold salt to dope graphene oxide and not all the peaks that proved the...
17 December 2020 9,275 3 View
14 December 2020 5,935 3 View
I am trying to make stably expressing cell line of my gene of interest in Suspension cell line using retrovirus but i don't have recommended protocol. I have searched literature but mostly they...
14 December 2020 8,274 3 View
I have done all optical simulations in RF module, now how can i find generation rate of electrons and holes, secondly how can i use these generation rate in semiconductor module to find further...
11 December 2020 6,652 3 View
Can a mathematical model be added to a paper on bean genetic and diseases manuscript?
10 December 2020 2,300 14 View
Hi all, I am validating a polyclonal antibody raised against human ANT4, through WB and ICC. In most of my controls, the antibody shows very little off-target binding, but when I pre-incubate the...
03 March 2021 5,999 3 View
Hi, Could you help me to get the latest (2019, 2020) solar resource data for a particular site in JAPAN? PV GIS and NSRDB data are not in reach to JAPAN, I'm looking for some other database for...
03 March 2021 961 3 View
Hello, I have a mechanism where air rises due to convective flows. In this simulation, nothing is driving the air except this. I understand that the Boussinesq approximation only works for small...
02 March 2021 4,910 3 View
I need to prepare a solution of Napabucasin (inhibitor of cancer cell stemness) in dichloromethane. The drug is expensive, so maybe somebody already tried to do it. If it is soluble, what is the...
02 March 2021 9,945 3 View
im working now on TPV solar cells and metamaterials and i realy need our help in CST microwave i have a tpv cell simulation and i want to extract particullarly the absorbtion of only the active...
02 March 2021 2,246 2 View
I am thinking about working on solar furnace with heliostats that concentrate sunlight and heat molten salt, but currently no luck with research. Not a lot of papers based on the subject. (check...
01 March 2021 5,023 5 View
I am designing a small grid connected solar PV power-plant. As the battery's capacity is specified in Ah and demand in kWh. What is the best way to size the battery bank? I have battery price in...
28 February 2021 1,638 3 View
28 February 2021 2,534 2 View
I have a doubt on how to select the inductor and capacitor value when I want to implement MPPT controller. This is because we always take a maximum output voltage and current but in this case, we...
28 February 2021 3,637 2 View
I diluted siRNA and RNAiMAX in opti-MEM and added to the cells which they were in the growth medium. Is it a right way? or should I culture cells in the opti-MEM medium for a while and not in...
26 February 2021 10,041 3 View
