Can we expect supercapacitor behavior from semi-conductor Nanoparticles in Electrochemical Impedance Spectroscopy analysis?

Theivasanthi Thirugnanasambandan @Theivasanthi-Thirugnanasambandan

24 July 2013 0 2K Report

What are the Parameters to identify super-capacitor (Niquist plot & Bode plot) in EIS?

Badges
Science topic

More Theivasanthi Thirugnanasambandan's questions See All

What are the indexing procedures in powder XRD?

I have Konjac powder (plant material). I do not know the structure. How can I do the indexing of this powder material?

24 September 2013 7,596 5 View

I have calculated bandgap value of lead (Pb) nanoparticles and got two results. Can anyone suggest which one is the accurate result?

band gap calculation of nanomaterials by UV -Vis, Photoluminiscence and Cyclicvoltammetry

16 September 2013 6,939 3 View

Does the agglomeration of nanoparticles lead to formation of bulk material?

Agglomeration of Cu nanoparticles lead to formation of bulk copper?

16 September 2013 2,903 1 View

Can anyone explain the main reasons/factors for the different behaviours of nanomaterials?

Behaviors of nanomaterials different from bulk material.

15 September 2013 8,205 11 View

If we made a pellet with nanoparticles: Will the particles in the pellet maintain its nanoscale or will change into bulk form?

If change to bulk form - What is the reason? How it is possible?

14 September 2013 3,747 3 View

Is it possible to change nanoparticles into bulk material?

Transformation from nanoparticles into bulk

14 September 2013 3,784 9 View

How to measure size of lead (Pb) nanoparticle from VSM (Vibrating Sample Magnetometer)?

TEM analysis shows Pb nanoparticle size is 10 nm.

01 May 2013 8,023 5 View

Is There Any Feasible Method To Test Fluorescent Compounds Other Than Fluorescence Spectrometers ??

Is There Any Feasible Method To Test The Efficiency Of Fluorescent Compounds Other Than UV Spectrometers ? Suggestions Would Be Appreciated !

02 March 2021 5,785 3 View

Why initial concentration of Pb not the same as calculated one when testing using AAS?

I am currently doing research on the adsorption of heavy metal using magnetic reduce graphene oxide. I use AAS to determine the concentration of the heavy metal. I prepare the Pb solution with...

26 February 2021 9,580 4 View

Is this the write procedure for acid digestion of soil for heavy metal analysis using AAS?

How to do acid digestion of soil sample with 3:1 aquaregia in an open vessel?

23 February 2021 3,053 7 View

Is there an ideal incubation time of RGO-modified SPCE before subsequent use, i.e., electrochemical characterization or further modification?

I notice that upon washing and air-drying of my RGO/SPCE surface and characterizing again via DPV, the current response towards ferricyanide probe significantly decreases. My worry is that the...

22 February 2021 5,324 3 View

Is that possible to do an impedance measurement without FRA module?

One of my colleagues said, "the impedance you can measure with the three electrodes and with the specific sequence varying the frequency" Is it possible to configure the potenciostat without the...

21 February 2021 418 2 View

How can I simulate the optical absorption spectrum of a biomaterial (like DNA or protein) in COMSOL?

I need to simulate the optical properties of a biomaterial, namely DNA, in COMSOL. Basically I need to simulate the IR absorption spectrum of a cylinder filled with a 'concentration' of DNA. I am...

21 February 2021 3,043 3 View

Unusually Busy Raman Background?

Hello, I am observing a nearly periodic background spectrum for a wide variety of SERS substrates. I see this response (attached below) for bare Au films, Cu films, and Au nanoparticles on...

15 February 2021 9,922 5 View

How to determine the drug loading and the drug release capacity of a polymer micelle using UV spectroscopy?

Currently, I am working on PLA-PEG copolymer micelle for the drug delivery system. I have seen several papers where some researcher talks to centrifuge the drug-loaded micelle to separate the...

13 February 2021 5,822 7 View

Is there any method that we can electrochemically oxidize a powder?

I am working with a material which is sensible to water and oxygen, I would like to oxidize this powder either chemical or electromagnetically. Does anyone knows a method to electrochemically...

09 February 2021 2,944 3 View

Please how can i write a proposal on the methodolgies of AAS to determine heavy metalsin water?

Please I want to write a proposal on the methodologies of AAS to determine heavy metals in water. please any link can help.

08 February 2021 3,587 7 View