Can we do dual fuel engine (H2-DIesel) analysis in GT-POWER?

More Ganesh Kerkal's questions See All

How do I plot a heat release rate curve of a diesel engine, given that I only know the engine specification and amount of fuel added per cycle?

31 December 2013 3,812 1 View

Can I plot a heat release rate curve for a diesel engine?

Only engine specification and amount of fuel added per cycle are known.

31 December 2013 4,164 1 View

Is there any block in simulink which allows specific block to run for given time period?

I made a simulink model and simulation time is 60, in which there is one subsystem which I want to run for only 20 to 40 time period. I don't want any output from that subsystem beside this...

31 December 2013 5,112 3 View

Geotechnical Engineering (Proceedings of the ICE) time review?

Hello everyone, I recently submitted an article to Geotechnical Engineering (Proceedings of the ICE), and the current status has been listed as "EiC Pre-assessment: Ready" for the past 20 days. I...

10 August 2024 6,493 1 View

Why results of ROS flurescence are negative as there was no bacteria within?

Hello. I am working on ROS production of two systems: system A is cerium oxide and hydrogen peroxide, system B is cerium oxide nanoparticle, hydrogen peroxide and potassium bromide. I did some...

04 August 2024 5,974 3 View

Question about combustion Kinetics ?

I am currently working on modeling FCC catalyst regeneration and have come across a point of uncertainty that I hope you can assist me with. In my previous models, I have utilized lumped kinetics...

30 July 2024 6,137 0 View

What should a Mechanical Engineering PhD scholar focus on during their PhD to enhance their chances of securing a postdoctoral position?

29 July 2024 7,714 4 View

May I know the exact Quartile of the journal- Advanced Engineering Materials (Wiley) for material science category?

In some data sources it has been grouped in Q1 and some shows it is Q2.

29 July 2024 4,227 2 View

Ternary in Electrical Engineering?

Dear Research Community I would like to invite Elctrical Engineering specialists to solve problems related to Ternary Algebra or tripple sets I have an algorithm that places in relation three...

28 July 2024 5,771 2 View

What topic or subject does Production Engineering need to address more?

Contemporary scores or innovations in scientific approaches. Hybrid methodologies, emerging themes and cross-cutting issues?

27 July 2024 648 3 View

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM images?

Does it exist some special technique for cutting ceramic membranes for Cross-sectional FESEM or SEM images?

25 July 2024 5,482 2 View

Can a shoot-through event of a tri-state digital buffer cause momentary Hi-Z state?

// interested in the difference between floating events and short circuits.

22 July 2024 6,565 0 View

Is there a good macro photography kit for on-site metallurgical investigation?

I am looking to purchase a photography kit for onsite metallurgical investigations, such as capturing photos of worn areas, hot tears, cold tears etc. Could anyone suggest me a good...

22 July 2024 3,490 2 View

Rupesh Gosavi

You might be required to model new engine with Two Fuel Injectors. Search for some research papers to get experimental values of different parameters, so that you can use it in GT model.

Duan Xiongbo

Hi, recently, I am calibrating GDI single cylinder engine by the GT Power, but it is difficult to calibrate the part load and the cylinder pressure is difficult to match the experimental data? what should I do?