Sample dilution for quantitative analysis using ELISA?

If the detection range is in ng/ml but the reference range is in ug/ml for a molecule or protein in serum or plasma .how to dilute and what is the initial volume to be taken for quantitative analysis

02 March 2021 7,670 3 View

What are the new 2D nanomaterials were used for Silver nanoparticles stabilization?

In the stabilization of AgNPs are vital in current research interest. However, some of the 2D nano-materials like graphene oxide, MoS2, etc... previously used to stabilize it. But still they shown...

01 March 2021 2,207 3 View

What information can be had from raman at higher wavenumber?

i have recorded raman spectra of strontium oxide thin film. the spectra were recorded in the range 400 to 4000 cm-1. i have reference to peaks upto 1000cm-1. but i couldn't find literature for...

26 February 2021 2,499 1 View

What are the methods used for CNT..?

Respected Professor's i hope you are doing well and happy. i need some information about carbon Nanotubes. before blending the CNT with the matrix the CNT has been introducing in some treatments....

24 February 2021 5,383 5 View

Langevin Dynamics in shear flow?

Hi, We are trying to simulate particles with Langevin dynamics in a shear flow by Lees-Edwards boundary conditions in MD simulations. It seems thermal forces and shear flow do not go hand in...

23 February 2021 1,761 1 View

How we can measure Kemp % in wool without using of benzene?

Would you please let me to know about the methods for measurement of medullation and Kemp % on animal? My problem is that the wool sampling and sending to laboratory is not possible. So I would...

21 February 2021 7,260 4 View

Which is the best software or programming language (user friendly) for analysing data?

I have a basic knowledge on Python, R and MATLAB in analysing data. Among those, which is the best and user friendly? Which one should I learn deeply to analyse data?N:B: I want to learn data...

20 February 2021 3,950 15 View

Hi..how to isolate crude HDL (all subfractions) from human serum by size exclusion chromatography?

I would like to know about isolation of crude HDL from serum by SEC. Is it possible to perform with a serum sample volume of

19 February 2021 5,576 2 View

What is the reason film thickness increased?

what is the reason film thickness increased when increased doping concentrations give some reasons The measured film thickness is 156, 282, 394, 548 and 681 nm for 0, 1.5, 2.5, 3.5, and 4.5 wt....

17 February 2021 8,987 5 View

How to perform Cox proportional hazard analysis or Kaplan-meier survival analysis in SPSS?

At first please see the attachment. This experiment was performed for a period of 7 days (n=100). After 7 days, we found different level of survival rate (%) for each treatment. Now, I want to...

15 February 2021 9,145 2 View

How could I process data in RCT to include it in meta-analysis?

I'm in the process of doing a meta-analysis and have encountered some problems with the RCT data. One of my outcom is muscle strength. In one study, I have three different measurements of muscle...

25 February 2021 7,603 3 View

I see 2 random bands in my ERK/pERK blot? Has anyone else seen this?

I ran a western blot using 12% gel and probing for ERK/pERK (cell signaling antibodies). The green is total ERK, the Red is supposed to be phospho-ERK. I see 2 bands below the total ERK that...

22 February 2021 1,777 3 View

ANCOVA controlling baseline in RCT - how to perform power analysis and sample size estimation?

Hi, I have a simple question. I am hoping to perform a power analysis/sample size estimation for an RCT. We will be controlling for baseline symptoms, and using post-treatment or change scores as...

19 February 2021 2,648 23 View

Is there any difference between "SEP" as a non standard residue and phohophorylated serine?

I am trying to run a molecular dynamics simulation for a ligand that contains a "SEP" residue. also, I am preparing my files using Charmm-GUI using charmm36 ff, but it says that it will rename my...

31 January 2021 6,321 1 View

Do i need to establish reliability in a quasi experimental study that seeks to employ a standardized instrument (WEAC & NECO past questions)?

I m carrying out a study on innovative teaching methods, the teaching methods are relatively new in the research area. however, teachers are to be trained on the application of these methods in...

24 January 2021 1,879 3 View

How to phosphorylate specific residues on pymol?

Hi everyone, I am using the pyTMs plug in on Pymol to phosphorylate a particular threonine in my protein. I am having difficulty in selecting only one or two residues - it seems I can only...

05 January 2021 230 3 View

Is it possible that the phosphorylated proteins mobilize faster than the non-phosphorylated ones?

The band downshifts on Western-blot, after kinase assay treatment.

23 December 2020 7,959 3 View

How to modify an article's "field of expertise" or "subspecialty"?

Greetings; I've recently published a preprint for a COVID treatment RCT, which appeared under "Dental" specialty instead of "Infectious diseases (ID)". This is an issue as it doesn't appear under...

14 December 2020 6,614 4 View

How to define least effective concentration (LEC) and maximum safe concentration (MSC) of drugs?

In drug delivery, for efficacy, the drug concentration needs to be within LEC and MSC. How can we define that concentration?

25 November 2020 6,478 3 View

How to perform intention-to-treat analysis for repeated measures data in SPSS?

25 November 2020 6,281 3 View