I found a solar cell block in Matab. Now I have to use it as an array so how should I connect this block? Otherwise I have my designed model of a cell, which will be better for an array of 10 KW.
U can use simulink to model the pv array. From the equation of pv cell, develop the model by combining the blocksets to represent the equation.
I used simulink model (equation model) for 2.5 kv . there are different models for pv array. try once.
All that is important in this case is for you to get the required mathematical equations models after which you use it either in the m-file or in the matlab simulink if it becomes difficult for you to get the appropriate equations
Sandia porvides the pvlib toolbox (http://pvpmc.org/pv-lib/) which implements some models.
You can have a look at theses:
https://uk.mathworks.com/matlabcentral/answers/183689-how-does-mppt-maximum-power-point-tracking-simulink-model-work
-Regards
you can have a look at these:
https://www.mathworks.com/help/physmod/sps/powersys/ref/pvarray.html
- Badges
- Science topic